LL-151-3D (serv.man2) - Sharp Monitor User Guide / Operation Manual. Page 13

Connect the supplied digital signal cable to the
digital RGB output terminal of the computer.
- The monitor has an input for connecting to a

computer with a DVI-compatible output
connector (DVI-D 24 pin or DVI-I 29 pin) and
XGA output capability. (Depending on the type of
computer to be connected, the display may not
work correctly.)

- Paying attention to connector direction, firmly

insert the signal cable vertically into the
connector, and then tighten the screws at both
sides.

Set the monitor as follows when establishing a
digital connection with a Power Mac using an ADC-
DVI adapter made by Belkin. (Operation has been
checked with the Power Mac G4 M7627J/A.)
- Perform settings with the Power Mac power

supply off.

1. Connect the AC adapter and the power cord.
2. Press the   button and   button simultaneously,

and while doing this press the power button (i.e.
turn the power on).

O K         [ M E N U ]

MAC DIGITAL

       

OFF

ON

3. Set to [ON] with the     buttons.

- Do not set to [ON] if you are not using a Belkin

ADC-DVI adapter, as this may result in
incorrect display.

4. Press the MENU button.

This completes setting.

Connect the supplied analog signal cable to the
analog RGB output terminal of the computer.

- Paying attention to connector direction, firmly

insert the signal cable vertically into the
connector, and then tighten the screws at both
sides.

If connecting to a D-sub 15 pin 2 row Apple Power
Macintosh, attach a Macintosh conversion adapter
(commercially available) to the analog signal
cable.

Analog signal cable

DVI-I input terminal

Analog RGB output terminal

Macintosh conversion adapter

Digital signal cable

Digital RGB output terminal

DVI-I input terminal