Read Sharp LB-1085 Service Manual online
LB-1085
TROUBLESHOOTING
7 – 1
CHAPTER 7. TROUBLESHOOTING
1 POWER LED FLASHING
*
The following chart is power green LED operation (1 cycle)
1
Power LED flashing timing table
2
Power abnormality
3
Lamp abnormality
4
The power is not supplied
5
The display is not shown / Display abnormality
6
The remote controller does not work
7
No sound / Reproduced sound abnormality
Lamp error
Lamp abnormality. If it occurs 5 times, the unit
cannot be turned ON. To boot forcibly, while
pressing [CH_Down] + [VOL_UP], turn AC_ON.
Refer to "3 Lamp abnormality."
cannot be turned ON. To boot forcibly, while
pressing [CH_Down] + [VOL_UP], turn AC_ON.
Refer to "3 Lamp abnormality."
Flashing Once
H:On
L: Off
Power error
Flashing twice
Between main CPU's
Communication error
Communication error
Flashing 3 times
Vsync
Flashing 4 times
Monitor temperature
error
error
Flashing 5 times
H:On
L: Off
H:On
L: Off
H:On
L: Off
H:On
L: Off
Power abnormality. Check the flashing pattern
of the OPC LED.
Refer to "2 Power abnormality."
of the OPC LED.
Refer to "2 Power abnormality."
Communication abnormality. Check the flashing
pattern of the OPC LED. Log analysis of the
debug print sentence, log analysis by the bus
monitor. Replace the main PWB.
pattern of the OPC LED. Log analysis of the
debug print sentence, log analysis by the bus
monitor. Replace the main PWB.
Panel temperature abnormality. Since the panel
temperature exceeds 60˚C, remove the factor
which causes the temperature rise.
temperature exceeds 60˚C, remove the factor
which causes the temperature rise.
VSYNC abnormality detection. Video process
IC operation abnormality.
Replace the main PWB.
IC operation abnormality.
Replace the main PWB.
Click on the first or last page to see other LB-1085 service manuals if exist.