R-95STM (serv.man3) - Sharp Home Appliance User Guide / Operation Manual. Page 43

Read Sharp R-95STM (serv.man3) User Guide / Operation Manual online

41
TROUBLESHOOTING
If you think the oven is not working properly
there are some simple checks you can carry out
yourself before calling an engineer. This will help
prevent unnecessary service calls if the fault is
something simple.
Follow this simple check below:
Place half a cup of water on the turntable and
close the door. Programme the oven to cook for
1 minute using 100% microwave power.
1. Does the oven lamp come on when it is
cooking?
2. Does the turntable rotate?
3. Does the cooling fan work? (Check by placing
your hand above the air vent openings.)
4. After 1 minute does the audible signal sound?
5. Is the water in the cup hot?
Take the cup of water out of the oven and close
the door. Programme the oven to cook for 3
minutes using the top and bottom grills.
6. After 3 minutes, does the grill heating
element become red?
Programme the oven to cook for 3 minutes using
the convection on 180ºC.
7. After 3 minutes, is the oven cavity hot?
If you answer “NO” to any question first check
that the oven is plugged in properly and the fuse
has not blown. If there is no fault with either,
check against the troubleshooting chart on the
following page.
NOTES:
• If you cook food for more than the standard
time (see chart opposite) using the same
cooking mode, the oven’s safety mechanisms
automatically activate. The microwave power
level will be reduced or the grill heating
element will turn on and off.
• After manual or automatic cooking using the
Grill, Dual Cook or Convection modes, the
cooling fan will switch on to cool the oven
cavity. When the cooling fan works, the display
may show “NOW COOLING”. To clear it,
press the STOP/CLEAR key and the display
will return to the time of day, if set.
During these modes, the cooling fan will carry
on working after you have pressed the
STOP/CLEAR key. You may feel hot air
blowing out of the air-vent openings.
IMPORTANT:
If the display is blank and has gone dark, even if
the power plug is properly connected, the oven
may be in Energy Save Mode. To cancel it, open
and then close the oven door, see page 9.
• The door seal stops microwave leakage during
oven operation, but does not form an airtight
seal. It is normal to see drops of water, light or
feel warm air around the oven door. Food with
a high moisture content will release steam and
cause condensation inside the door which may
drip from the oven.
• Repairs and Modifications: Do not attempt to
operate the oven if it is not working properly.
• Outer Cabinet & Lamp Access: Never remove
the outer cabinet. This is very dangerous due
to high voltage parts inside which must never
be touched, as this could be fatal.
Your oven is not fitted with a lamp access
cover. If the lamp fails, do not attempt to
replace the lamp yourself, call a SHARP
approved service facility.
WARNING:
Never adjust, repair or modify the oven
yourself. It is hazardous for anyone other
than a SHARP trained engineer to carry
out servicing or repairs.
This is important as it may involve the
removal of covers that provide protection
against microwave energy.
Cooking Mode
Microwave 100%
cooking
Grill cooking
Dual cooking with
Microwave 100%
and Grill
Microwave 70%
and Grill
Microwave and
Convection
Standard Time
20 Minutes
15 Minutes
Microwave 15 Minutes
Grill 15 Minutes
Microwave 40 Minutes
Grill 15 Minutes
Microwave 40 Minutes
VJCM Modular Op Man  23/01/2003  14:45  Page 41
Page of 49
Display

Click on the first or last page to see other R-95STM (serv.man3) service manuals if exist.