R-952M (serv.man2) - Sharp Home Appliance User Guide / Operation Manual. Page 8

6

STOP/CLEAR key

Your oven comes set for an “Energy Save” mode. When “Energy Save” mode is on, the microwave display will
show “.0” instead of the time of day.  If you do nothing for 2 minutes after the preceding operation, i.e. at the
end of cooking, the power will go off automatically and the display will show “OVEN IN ENERGY SAVE
MODE” just before the oven is in “Energy Save” mode.   The energy consumption of the oven will nearly equal
zero in the “Energy Save” mode. To restore the power, open and then close the door. “Energy Save”
mode will remain “on” until you set the clock.

To set the energy save mode:

3. Press the START/AUTO

MINUTE key once.

1. Press the AUTO START/CLOCK

key once.

2. Press the AUTO

START/CLOCK key again.

The display will show:

The display will show:

Your oven has an “Energy Save” mode.
1. Plug in the oven. Nothing will appear in the display at this time.
2. Open the door. The display will flash the message shown opposite.
3. Close the door. The oven display wil show “.0”. If you set the clock “Energy

Save” mode will be off. If you keep “Energy Save” mode, go to step 5.

4. Set the clock, refer to page 7. 
5. Heat the oven using the convection and grill without food for 20 minutes.

(For operation, see NOTES on page 10 and 11.

Use the STOP/CLEAR key to:
1. Erase a mistake during programming.
2. Stop the oven temporarily during cooking.
3. Cancel a programme during cooking, press twice.

R-952M O/M FINAL  1/7/99  2:03 pm  Page 6