R-895M (serv.man8). Component replacement and adjustment procedure - Sharp Home Appliance Service Manual (repair manual). Page 3

R-895M - 26

Terminal

Push

Pull down

1

2

Lever

Positive lock¤
connector

Cutting pliers

Bridges

Bridges

Turntable motor 
cover

Screw; 
LX-EZA045WRE0 

Turntable motor cover

Base plate  

Tabs 

Slits 

Coil

Gap

Rotor

Bracket

Stator

Groove joint pliers

Shaft

Axis

Stator

Rotor

These are the positions 
that should be pinched 
with pliers.

Shaft

Table

Center of
bracket

1. CARRY OUT 3D CHECKS.
2. Push the lever of positive lock

®

 connector.

3. Pull down on the positive lock

®

 connector.

CAUTION: WHEN YOU (SERVICE ENGINEERS) CON-

NECT THE POSITIVE LOCK

®

  CONNEC-

TORS TO THE TERMINALS, CONNECT
THE POSITIVE LOCK

®

  SO THAT THE LE-

VER FACES YOU.

Removal
2. Remove the turntable from the oven cavity.
3. Turn the oven over.
4. Cut the four (4) bridges holding the turntable motor

cover to the base plate with cutting pliers as shown in
Figure C-2(a).

CAUTION: DO NOT DROP THE TURNTABLE MOTOR

COVER INTO THE OVEN AFTER CUTTING
THE BRIDGES. BECAUSE IT WILL DAM-
AGE THE WIRE LEADS OF THE MOTOR
AND IT IS DIFFICULT TO REMOVE IT OUT
OF THE OVEN.

5. Remove the turntable motor cover from the base plate.
6. Disconnect the wire leads from the turntable motor.
7. Remove the one (1) screw holding the turntable motor

to the turntable motor angle.

8. Bend the turntable motor retaining tab back to release

the motor.

9. Remove the turntable motor from the turntable motor

angle. Now, the turntable motor is free.

Re-install
1. Remove the any sharp edges on the turntable motor

cover and the base plate with the cutting pliers.

2. Re-install turntable motor by locating shaft onto turnta-

ble motor shaft to the turntable motor angle with the one
(1) screw.

3. Bend the turntable motor retaining tab forward to se-

cure the motor.

4. Re-connect the wire leads to the turntable motor.
5. Insert the two (2) tabs of the turntable motor cover into

the slits of the base plate as shown in Figure C-2(b).

6. Re-install the turntable motor cover to the base plate

with the screw (LX-EZA045WRE0) as shown in Figure
C-2(b).