R-874 (serv.man10). Part 2 (Page 2-9) - Sharp Home Appliance User Guide / Operation Manual. Page 4

1. Remove all packing materials including the

feature sticker (if applicable). Do not remove the
plastic film from the inside of the oven window as
this protects it from dirt. The waveguide cover
prevents food and grease from entering the
waveguide area where it could cause damage.
DO NOT REMOVE.

2. Place oven on a secure, level surface, strong

enough to take the oven weight, plus the heaviest
item likely to be cooked in the oven.

3. The minimum height

of free space
necessary above the
top sur face of the
oven is 19cm.

4. The oven door may become hot during cooking.

Place or mount the oven so that the bottom of the
oven is 85cm or more above the floor.

5. Do not place the oven where heat, moisture or

high humidity are generated, (for example, near
or above a conventional oven) or near
combustible materials (for example, curtains). Do
not block or obstruct air vent openings. Do not
place objects on top of the oven.

6. Make sure the power supply cord is undamaged

(See IMPORTANT: ELECTRICAL CONNECTION!
below) and that it does not run under the oven or
over any hot or sharp surfaces. 

7. The socket must be readily accessible so that it

can be easily unplugged in an emergency.

8. Do not use the oven outdoors.

BUILDING-IN-KIT.
The R-884M microwave oven is not designed to be
built-in to a kitchen unit.

An installation frame is available for R-874M and
R-84STM which enables the microwave oven to be
integrated within a kitchen unit.
The microwave ovens are not designed to be built
above or near a conventional oven.
SHARP recommend the use of the build in kit,
EBR-4700 (R-874M) or EBR-47ST (R-84STM),
available from your SHARP dealer.  Only the use of
this frame will guarantee the quality and safety of
the oven. When building, follow installation
instructions carefully.

• Do not allow water to come into contact with the

power supply cord or plug.

• Insert the plug properly into the socket.

• Do not connect other appliances to the same

socket using an adaptor plug.

• If the plug or socket is loose or the power supply

cord is damaged, it must be replaced with a
special cord. The exchange must be made by an
authorised SHARP service agent. 

• When removing the plug from the socket always

grip the plug, never the mains lead as this may
damage the power supply cord and the
connections inside the plug.

• This product is fitted with a re-wireable plug.

Should it not be suitable for the socket outlet in
your home, remove the plug and fit an
appropriate type, observing the wiring code given
in `To replace the mains plug’ on page 65.

If you wish to remove or replace the plug supplied,
ensure the plug is removed properly and not cut off.
When replacing the plug please ensure that you use
a BSI or ASTA approved plug to BS1363, this should
be fitted with a brown coloured 13 amp fuse
approved by BSI or ASTA to BS1362. If you have
any doubt about electrical connection seek the help
of a qualified electrician. 

To wire an appropriate plug, follow the wiring code
given in `To replace the mains plug’ on page 65.

19cm

5

Website: http://www.sharp.co.uk/support

Help Line: 08705 274277 (office hours)

R-874M/R-84STM Op Man/Ck Bk  28/3/01  8:41 am  Page 5