Read Sharp R-269A User Guide / Operation Manual online
4
INSTALLATION
WARNING:
Inspect the Oven:
• Check the oven carefully for damage
• Check the oven carefully for damage
before and regularly after installation.
• Make sure the door closes properly,
that it is not misaligned or warped.
• Check the hinges and door safety
latches are not broken or loose.
• Ensure the door seal and sealing
surfaces are not damaged. If the
door or door seals are damaged, the
oven must not be operated until it
has been repaired by a competent
person.
door or door seals are damaged, the
oven must not be operated until it
has been repaired by a competent
person.
• Inspect the oven interior and door
for dents.
IMPORTANT:
If any damage is apparent, do not
If any damage is apparent, do not
operate the oven in any way, until
it has been repaired by a SHARP
trained engineer.
it has been repaired by a SHARP
trained engineer.
5. Make sure the power supply cord is undamaged
(See “ELECTRICAL CONNECTION” below).
Do not allow the power supply cord to
run over any hot or sharp surfaces,
such as the hot air vent area at the
top rear of the oven.
Do not allow the power supply cord to
run over any hot or sharp surfaces,
such as the hot air vent area at the
top rear of the oven.
6. The socket must be readily accessible so that
it can be easily unplugged in an emergency.
7. Do not use the oven outdoors.
BUILDING-IN-KIT.
No built-in kit is available for this oven.
This oven is designed to be used on a countertop
only.
No built-in kit is available for this oven.
This oven is designed to be used on a countertop
only.
ELECTRICAL CONNECTION.
• Do not allow water to come into contact with
• Do not allow water to come into contact with
the power supply cord or plug.
• Insert the plug properly into the socket.
• Do not connect other appliances to the same
• Do not connect other appliances to the same
socket using an adaptor plug.
• If the power supply cord is damaged, it must
be replaced by a Sharp approved service facility
or a similarly qualified person to avoid a hazard.
or a similarly qualified person to avoid a hazard.
• When removing the plug from the socket
always grip the plug, never the cord as this
may damage the power supply cord and the
connections inside the plug.
may damage the power supply cord and the
connections inside the plug.
• If the plug fitted to your oven is a rewireable
type and in the event of the socket outlet in
your home not being compatible with the plug
supplied, remove the plug properly (do not cut
off).
your home not being compatible with the plug
supplied, remove the plug properly (do not cut
off).
• If the plug fitted to your oven is a non-rewirable
type and in the event of the socket outlet in
your home not being compatible with the plug
supplied, cut-off the mains plug.
your home not being compatible with the plug
supplied, cut-off the mains plug.
• Refit with a suitable type, observing the wiring
code given in ‘To replace the mains plug’ on
page 38.
page 38.
1. Remove all packing materials including the
feature sticker (if applicable). Do not remove
the plastic film from the inside of the oven
window as this protects it from dirt. The
waveguide cover prevents food and grease
from entering the waveguide area where it
could cause damage. DO NOT REMOVE THE
WAVEGUIDE COVER.
the plastic film from the inside of the oven
window as this protects it from dirt. The
waveguide cover prevents food and grease
from entering the waveguide area where it
could cause damage. DO NOT REMOVE THE
WAVEGUIDE COVER.
2. Place oven on a secure, level surface. Ensure
it is strong enough to take the oven weight,
plus the heaviest item likely to be cooked in
the oven.
plus the heaviest item likely to be cooked in
the oven.
3. The minimum height
of free space necessary
above the top surface
of the oven is 15cm.
above the top surface
of the oven is 15cm.
4. Do not place the oven where heat, moisture
or high humidity are generated, (for example,
near or above a conventional oven) or near
combustible materials (for example, curtains).
Do not block or obstruct air vent openings.
Do not place objects on top of the oven.
near or above a conventional oven) or near
combustible materials (for example, curtains).
Do not block or obstruct air vent openings.
Do not place objects on top of the oven.
15cm
R-269-A [EN].indd 4
R-269-A [EN].indd 4
6/25/09 11:15:06 AM
6/25/09 11:15:06 AM
Click on the first or last page to see other R-269A service manuals if exist.