R-24AT (serv.man5) - Sharp Home Appliance User Guide / Operation Manual. Page 29

A35558,SUK R22AT/24AT O/M

• Do not allow grease or dirt to build up on the door

seals and adjacent parts as this may prevent the
door from closing correctly and may cause a leak-
age of microwaves. To clean use a mild detergent
solution on a soft damp cloth.

• Keep the ceramic floor clean at all times. If you leave

grease or fat in the cavily, it may overheat, smoke or
even catch fire when next using the oven.

• Never use spray cleaners, oven pads or abrasive scour-

ers as these damage the surface of the oven.

• Do not remove the ceramic floor from the oven.
• Do not use commercial oven cleaners, abrasive or

harsh cleaners or scouring pads on any part of your
microwave oven.

• Do not sprinkle water onto the oven directly. It may

cause electric shock, leakage of electricity or damage
of the oven.

• DO NOT OPERATE the oven without the splash cover

in place.

• DO NOT REMOVE the splash cover UNLESS THE

POWER CORD IS REMOVED FROM THE OUTLET
because the rotary antenna, which is located on the
ceiling, operates for 1 minute after the door is opened
and injury could occur.

Clean the microwave oven cavity, at the end of each day
with a damp soft cloth for hygienic reasons. For heavier
soil, use mild soap applied with a soft damp cloth wipe
clean ensuring all soap is removed. Make sure that the
soap or water does not penetrate through the small vents
in the walls which may cause damage to the oven. Take

care not to let soapy water drip through the small holes in
the oven walls. Excess water spillage through these holes
will cause damage to the oven interior. It is important that
the door seals and sealing surfaces are kept clean at all
times, wipe regularly with a damp cloth.
The ceramic floor should be kept clean at all times. Minor
spills may be wiped with a damp cloth.

Removal:
1. Remove two thumb screws (A) as shown in Fig.1.
2. Remove the splash cover from the oven.

(A)

Door

Splash cover

Fig. 1

Reinstall:
1. Insert two projections of the cover (B) into the holes of

the oven cavity backplate as shown in Fig. 2.

2. Secure the cover to the oven ceiling with two thumb

screws (A) as shown in Fig. 1.

Hole

Clip

Air intake filter

Clip

Hole

Oven

Air intake filter

(B)

Splash cover

Holes

Fig. 2

Wipe the outside cabinet with a mild detergent solution
on a soft cloth. The control panel must be wiped clean
whilst the door is open, therefore inactivating the oven.
Keep the air intake filter clean. Clean the air intake filter
once every two weeks.
Remove the air intake filter by pulling the two (2) clips on
the sides of the filter.
Wash the air intake filter in mild soapy water, rinse and dry
with a soft cloth.
After cleaning re-install the air intake filter.
Do not operate the oven without the air intake filter in place.

Untitled-7

04.1.9, 8:21 PM

28