R-246 (serv.man2). Complete - Sharp Home Appliance Service Manual (repair manual). Page 18

16

To remove the outer case proceed as follows.
1. Disconnect the oven from power supply.
2. Open the oven door and wedge it open.
3. Remove the eight (8) screws from rear and along the

side edge of case.

4. Slide the entire case back about 3cm to free it from

retaining clips on the cavity face plate.

5. Lift the entire case from the oven.

6. Discharge the H.V. capacitor before carrying out any

further work.

7. Do not operate the oven with the outer case removed.
N.B.; Step 1, 2 and 6 form the basis of the 3D checks.

CAUTION: DISCHARGE HIGH VOLTAGE CAPACI-

TOR BEFORE TOUCHING ANY OVEN
COMPONENT OR WIRING.

1. Disconnect oven from power supply.
2. Visually check the door and cavity face plate for dam-

age (dents, cracks, signs of arcing etc.).

Carry out any remedial work that is necessary before
operating the oven.
Do not operate the oven if any of the following conditions
exist;
1. Door does not close firmly.
2. Door hinge, support or latch hook is damaged.
3. The door gasket or seal is damaged.

4. The door is bent or warped.
5. There are defective parts in the door interlock system.
6. There are defective  parts in the microwave generating

and transmission assembly.

7. There is visible damage to the oven.

Do not operate the oven:
1. Without the RF gasket (Magnetron).
2. If the wave guide or oven cavity are not intact.
3. If the door is not closed.
4. If the outer case (cabinet) is not fitted.

To prevent an electric shock, take the following
manners.
1. Before wiring,

1) Disconnect the power supply.
2) Open the door and wedge the door open.
3) Discharge the high voltage capacitor and wait for

60 seconds.

2. Don't let the wire leads touch to the following parts;

1) High voltage parts:

Magnetron, High voltage transformer, High volt-
age capacitor, High voltage fuse and High voltage
rectifier assembly.

2) Hot parts:

Oven lamp, Magnetron, High voltage transformer
and Oven cavity.

3) Sharp edge:

Bottom plate, Oven cavity, Waveguide flange,
Chassis support and other metallic plate.

4) Movable parts (to prevent a fault)

Fan blade, Fan motor, Switch.

3. Do not catch the wire leads in the outer case cabinet.
4. Insert the positive lock connector certainly until its pin

is locked. And make sure that the wire leads should
not  come off even if the wire leads is pulled.

5. To prevent an error function, connect the wire leads

correctly, referring to the Pictorial Diagram.

Please refer to ‘OVEN PARTS, CABINET PARTS, CONTROL PANEL PARTS, DOOR PARTS’, when carrying out any
of the following removal procedures:

1. CARRY OUT 3D CHECKS.
2. Disconnect the wire leads (main wire harness and H.V.

fuse) from high voltage transformer.

3. Disconnect the filament lead of high voltage trans-

former from the magnetron.

4. Disconnect the filament lead of the high voltage trans-

former from high voltage capacitor.

5. Remove the two (2) screws holding the transformer to

bottom plate from below.

6. Remove the two (2) screws holding the transformer to

bottom plate from above.

7. Remove the transformer.