R-210AM. Complete - Sharp Home Appliance Service Manual (repair manual). Page 6

210AM - 6

1.

CARRY OUT 3D CHECKS.

2.

Remove choke cover taking care not to break
clips.

3.

Remove door assembly by lifting and easing
it forward.

4.

On re-installation make sure the door is
parallel with the bottom line of the oven face
plate and the latch head pass through the
latch holes correctly.

5.

CARRY OUT 4R CHECKS.

NOTE : After any service to the door, the

approved microwave survey meter should be
used to assure in compliance with proper
microwave radiation standards.

1.

Insert an iron plate (thickness of about 0.5mm) or
flat type screw driver to the gap between the choke
cover and door panel as shown figure to free the
engaged part.  The protect sheet may be used not
to damage the door panel.

2.

Lift up the choke cover, now the coke cover is free.

LATCH HEAD REMOVAL
1.

Remove the choke as above.

2.

Unhook the spring and lift the latch head clear.

3.

Replacement, the reverse of the above.

Removal
1.

Tear the door film from the door panel.

2.

Now the door film is free.

Installation
1.

Tear away the backing film.

2.

Put the pasted side of the door film on the door
panel.

Finger tab

Door film

Backing film

DOOR ASSEMBLY

OUTER CASE
CABINET

LATCH HEADS

FLAT TYPE
SCREW-DRIVER

PROTECT BY TAPE

CHOKE
COVER

DOOR
PANEL

1. Remove  the door film from the clips on the door frame.

Installation
1. Attach  the door film to the clips on the door frame.

Adhesive tape

Finger tab

Door film

Backing film