Read Sharp R-201 (serv.man2) Service Manual online
R-201M - 6
COMPONENT REPLACEMENT
Note: After any service to the door;
(A) Make sure that monitored latch switch,latch
(A) Make sure that monitored latch switch,latch
switch and monitor switch are operating
properly.
properly.
(B) An approved microwave survey meter
should be used to assure compliance with
proper microwave radiation emission
limitation standards
proper microwave radiation emission
limitation standards
DOOR REPLACEMENT
1.
CARRY OUT 3D CHECKS.
2.
Remove choke cover taking care not to break
clips.
clips.
3.
Remove door assembly by lifting and easing
it forward.
it forward.
4.
On re-installation make sure the door is
parallel with the bottom line of the oven face
plate and the latch head pass through the
latch holes correctly.
parallel with the bottom line of the oven face
plate and the latch head pass through the
latch holes correctly.
5.
CARRY OUT 4R CHECKS.
NOTE : After any service to the door, the
approved microwave survey meter should be
used to assure in compliance with proper
microwave radiation standards.
used to assure in compliance with proper
microwave radiation standards.
CHOKE COVER REMOVAL
1.
Insert an iron plate (thickness of about 0.5mm) or
flat type screw driver to the gap between the choke
cover and door panel as shown figure to free the
engaged part. The protect sheet may be used not
to damage the door panel.
flat type screw driver to the gap between the choke
cover and door panel as shown figure to free the
engaged part. The protect sheet may be used not
to damage the door panel.
2.
Lift up the choke cover, now the coke cover is free.
Finger tab
Door film
Backing film
DOOR ASSEMBLY
OUTER CASE
CABINET
CABINET
LATCH HEADS
Figure C-6. Door Assembly Replacement and
Adjustment
NOTE: When carring out any repair to the door,
do not bend or warp the slit choke (tabs on
the door panel assembly) to prevent
microve leakage.
the door panel assembly) to prevent
microve leakage.
FLAT TYPE
SCREW-DRIVER
SCREW-DRIVER
PROTECT BY TAPE
CHOKE
COVER
COVER
DOOR
PANEL
PANEL
OUTER DOOR FILM
Removal
1. Remove the door film from the clips on the door frame.
Installation
1. Attach the door film to the clips on the door frame.
1. Attach the door film to the clips on the door frame.
Adhesive tape
Finger tab
Door film
Backing film
INNER DOOR FILM
Removal
1.
1.
Tear the door film from the door panel.
2.
Now the door film is free.
Installation
1.
1.
Tear away the backing film.
2.
Put the pasted side of the door film on the door
panel.
panel.
LATCH HEAD REMOVAL
1.
1.
Remove the choke as above.
2.
Unhook the spring and lift the latch head clear.
3.
Replacement, the reverse of the above.
NOTE: When carring out any repair to the door,
do not bend or warp the slit choke (tabs on
the door panel assembly) to prevent
microve leakage.
the door panel assembly) to prevent
microve leakage.
SLIT CHOKE
Click on the first or last page to see other R-201 (serv.man2) service manuals if exist.