VENTA PRO V3 (serv.man26). Version History (Bugs and Specification changes) Up to Venta Pro V3.1.1073 - Sharp EPOS Driver / Update. Page 3

Read Sharp VENTA PRO V3 (serv.man26) Driver / Update online

254 
When performing splits the free text was lost. Now fixed 
 
 
253 
Occasionally an Ocius completion was not being registered by SharpPOS. Now 
fixed 
 
 
252 
When using the PROMOCALCBYITEM setting - in NSplit the line discount wasn't 
being split. Now fixed 
 
 
251 
It is no longer possible to use F39 (refunds) to perform refunds for mix and match 
transactions due to the increasing complexity of the calculations, F81 
Transaction Reverse should now be used. 
 
 
02/02/11 
Venta Pro V3.1.994 VPM V1.2.199 
 
 
250 
When paying using a deposit and the deposit was set to overtender but not 
change. The message Overtender not allowed was displayed and the deposit 
was then locked to till 1. Now fixed. The overtender message still shows but the 
deposit is not locked out. 
 
 
26/01/11 
Venta Pro V3.1.993 VPM V1.2.199 
 
 
249 
Standard Hotel Interface - $ITEM line had been incorrect from introduction of V5 
in 12-02-2002 until 29-04-2010. For compatibility a new setting can be used 
HOTELSTDV5_OLD=1 
 
 
248 
When using a training server and splitting bills only the main table could be 
cashed off, now all splits can be cashed off. 
 
 
247 
YesPay and refunds - the payment amount in payment record after completion 
was not being made negative (payment.amnt); Cashrsp reported positive 
payments (Reverse tran was OK) 
 
 
246 
Applying subtotal discounts didn't examine discountability of item discounts. 
They now do, but will only apply to item discounts whose parent product are also 
Correspondingly discountable. 
 
 
245 
Spurious discount by line values appearing in CashRsp. Now fixed 
 
 
244 
Changes made to cash drawer switch detection for UP-5500 
 
 
243 
Problem with discount calculations now fixed. 
 
 
242 
Active Tables were sometimes slow updating table status. 
fixed 
 
 
17/11/10 
Venta Pro V3.1.979 VPM V1.2.199 
 
241 
Feature Added 
Allow big change/payment screen for payment method Cheque.
 
 
 
240 
Feature Added 
Previously when listing the outstanding credit card transactions on the Chip and 
Pin terminal within the ‘Get Bill’ list, the transactions where displayed as ‘Tab’ 
(table) number or ‘Srv’ (Server) number. 
It is now possible to display the outstanding credit card transaction using the 
following combination of the till number and appended to this the last 3 digits of 
the transaction number, e.g. on till 4 it could be 4012 
 
 
239 
Feature Added 
Currently when applying discounts any subtotal discount applied are always 
Page of 21
Display

Click on the first or last page to see other VENTA PRO V3 (serv.man26) service manuals if exist.