Read Sharp UP-X500 (serv.man5) Service Manual online
UP-X500I
Removing the rear cover unit
– 1 –
1. Removing the rear cover unit
Remove the screw
1
, and remove the rear cover unit
2
.
2. Removing the side cover
Slide the lever
1
to release the lock. Slide the side cover
2
toward
you and rotate and remove it.
3. Removing the LCD unit
3-1. Removing the top cover section
Remove each screw
1
, and lift the rear side of the top cover
section
3
and disconnect each connector
2
and remove.
3-2. Removing the Top cover unit
Caution: Top cover unit
7
is pushed down.
1. Remove the screw
1
, and remove the wire holder
2
.
[Screw
1
is Black.]
2. Remove the screw
3
, and remove the wire holder
4
.
3. Remove the core
5
of the T/P cable.
4. Remove four screws
6
, and disassemble the top cover unit
7
.
Precautions
• Before installation, be sure to turn off the power.
• Use gloves to protect your hands from being cut by the angle and
the chassis.
• Connect all the cables securely. When connecting or disconnecting
the cables, be careful not to apply stress to the cables. (It may
cause disconnection.)
• Ground the human body to prevent against troubles and dust adhe-
sion to the LCD by static electricity. When assembling the LCD, use
a discharge blower to prevent against dust intrusion.
a discharge blower to prevent against dust intrusion.
• Be careful of the high voltage of the inverter PWB transformer.
• Place the top cabinet with LCD panel side down, Please use a clean
dust free clothe to protect the touch panel and LCD area.
1
1
2
2
1
1
1
1
1
2
2
3
1
2
3
4
5
6
6
7
Click on the first or last page to see other UP-X500 (serv.man5) service manuals if exist.