Read Sharp UP-V9900 (serv.man3) Service Manual online
2-5
Using BIOS
Introduction
Expansion
Installation Locations
Connecting Peripheral Devices
Turn On and Off the System Restoring HDD Drive to factory default configuration
Setting
Appendix A Appendix B
Troubleshooting
Connecting the RJ-45 LAN Connector
The system has an RJ-45 network cable jack and activity status light on
the front of the system. You can connect the RJ-45 network cable from
RJ-45 network jack to both 10Base-T and 100Base-TX. Because the
LAN subsystem is completely software-configurable, you need not to
set any jumper.
the front of the system. You can connect the RJ-45 network cable from
RJ-45 network jack to both 10Base-T and 100Base-TX. Because the
LAN subsystem is completely software-configurable, you need not to
set any jumper.
Connect one end of the FU-45 cable provided with the system to
the RJ-45 connector on the system and connect the other end of
the cable to an external LAN hub.
the RJ-45 connector on the system and connect the other end of
the cable to an external LAN hub.
<LAN Hub>
Your terminal has two USB connectors on the right side of LCD monitor and
rear side of the system for attaching USB-compliant devices. If you have any
USB devices, you can connect them to either USB connector. USB devices are
peripherals such as a keyboard, mouse, CCD camera, and printer.
rear side of the system for attaching USB-compliant devices. If you have any
USB devices, you can connect them to either USB connector. USB devices are
peripherals such as a keyboard, mouse, CCD camera, and printer.
To connect any USB device to the USB connector, plug the cable connector
from the USB device with any mark on the connector facing up into either
USB connector marked with ‘USB’ on the right side of the system. You can
plug in USB devices while the system is running. To use more than four
USB devices, you can connect a USB hub to either USB connector.
from the USB device with any mark on the connector facing up into either
USB connector marked with ‘USB’ on the right side of the system. You can
plug in USB devices while the system is running. To use more than four
USB devices, you can connect a USB hub to either USB connector.
Connecting USB devices
or
or
<CCD Camera>
<Keyboard>
<
M
Moouussee
>
Click on the first or last page to see other UP-V9900 (serv.man3) service manuals if exist.