UP-V5500 (serv.man9). User Manual - Sharp EPOS User Guide / Operation Manual. Page 5

 

 

IN NO EVENT WILL FARSTONE OR ITS LICENSORS BE LIABLE TO YOU FOR ANY INCIDENTAL, 

CONSEQUENTIAL OR INDIRECT DAMAGES, INCLUDING ANY LOST PROFITS, LOST SAVINGS, 
OR LOSS OF DATA, EVEN IF FARSTONE OR A LICENSOR HAS BEEN ADVISED OF THE 

POSSIBILITY OF SUCH DAMAGES, OR FOR ANY CLAIM BY ANY OTHER PARTY. Some states do 
not allow the exclusion or limitation of special, incidental, or consequential damages, so the 

above limitation or exclusion may not apply to you.   

You acknowledge that you have read this Agreement, understand it, and that by using the 

“Software” you agree to be bound by its terms and conditions. You further agree that it is the 
complete and exclusive statement of the agreement between FarStone and you, and 

supersedes any proposal or prior agreement, oral or written, and any other communication 
between FarStone and you relating to the subject matter of this Agreement. No additional or 

any different terms will be enforceable against FarStone unless FarStone gives its express 
consent, including an express waiver of the terms of this Agreement, in writing signed by an 
officer of FarStone. You assume full responsibility for the use of the “Software” and agree to use 

the “Software” legally and responsibly.   

Should any provision of this Agreement be declared unenforceable in any jurisdiction, and then 

such provision shall be deemed severable from this Agreement and shall not affect the 
remainder hereof. FarStone reserves all rights in the “Software” not specifically granted in this 

Agreement.  

 

 
   
 

In addition to the above agreement, the following terms and conditions will also apply to Your 
use of the Software:     

 

You may use the Software on one Device to clone, or apply an image of a hard drive on that 

Device, or to another hard drive on the same Device, a replacement Device, secondary media, 

or network drive.     
 

You may use the Software on a Device to create an image file of a hard drive on that Device 

and store the image file on fixed or removable media for disaster recovery purposes. 

 

You may use the Software as a boot disk to re-apply the hard drive image that was created 

for disaster recovery purposes to the hard drive on the Device from which the disaster recovery 

image was made or on a replacement Device provided that the software has been removed 
from the original Device. 

 

You may use the Software to clone a hard drive from a Device to a replacement Device, in 

the manner described in the Software documentation and to use the Software on the 
replacement Device provided that the Software has been removed from the original Device.