ER-A850 (serv.man6). ERA850 880 Option Installation manual - Sharp EPOS Service Manual (repair manual). Page 2

Read Sharp ER-A850 (serv.man6) Service Manual online

Before installation, be sure to turn off the power.
Use gloves to protect your hand from being cut by the angle
and the chassis.
Connect all the cables securely. When connecting or discon-
necting the cables, be careful not to apply stress to the ca-
bles. (It may cause disconnection.)
Ground the human body to prevent against troubles and dust
adhesion to the LCD by static electricity. When assembling
the LCD, use a discharge blower to prevent against dust intru-
sion.
Be careful to the high voltage of the invertor PWB trans-
former.
 Precautions
1. Removing the rear cover.
1) Remove the two screws 
1
 suited on the lower cabinet.
2) Remove the rear cover 
2
 in the direction of arrow 
A
.
2. Replacing the rear cover
Install the rear cover in the reverse order of removing.
3. Removing the top cabinet
1) Remove the two screws 
1
 suited on the lower cabinet.
2) Remove the top cabinet.
a) Lift the rear edge of the top cabinet in the direction of arrow
A
.
b) Slide the top cabinet in the direction of arrow 
B
 and remove
three pawls of the bottom cabinet at the same time. (Be careful
not to break the pawls.)
c) Lift the top cabinet and put it straight in the direction of arrow
C
. (Be careful not to pull the cable between the top cabinet
and the main PWB excessively.)
1
2
d) Pull and remove the following cables between the top cabinet
and the main PWB.
Cable 
2
 between the main PWB and the invertor PWB:
(CON25)
Cable 
3
 between the main PWB and the LCD: (CON4)
Cable 
4
 between the main PWB and the IOC PWB: (CON7)
(CON7 employs the lock type connector. To remove, re-
lease the lock and pull the cable.)
4. Replacing the top cabinet
1
1
A
B
4
2
3
C
– 1 –
Page of 7
Display

Click on the first or last page to see other ER-A850 (serv.man6) service manuals if exist.