XE-A213 (serv.man3). XE-A213 Programming Manual - Sharp ECR Service Manual (repair manual). Page 26

XE-A203/A213

OP X/Z, X1/Z1, X2/Z2 MODE

3 – 2

•  Stop of printing reports (Report cancel function):

This ECR has the function of report stopping for PLU report and EJ
report.

•  Printing of GT on X reports:

This ECR dose not print any GT on X reports.

*1 To read respective reports, it is necessary to follow the procedure

below.

*2 PLU code range can be specified by entering the start and end

numbers according to the following procedure.
When specifying a single PLU code, the start number has only to be
entered.

*3 The clerk code does not need to enter at the OPX/Z mode.

In OPX/Z mode, it is issued the report of the assigned cashier.

*4 Reading display only.

The displayed amount can be cleared by [CL] key.

*5 To read respective contents, it is necessary to follow the procedure below.

*6 It is able to print and clear the EJ memory at general Z1 report by

PGM mode programming.
In that case, the contents of EJ memory is printed just after issued
general Z1 report.
(Issuing general Z1 report 

3 Clear daily DEPT & TRANS memory 3

Issuing EJ memory 

3 Clear EJ memory)

*7 To read respective contents, it is necessary to follow the procedure

below.

Individual counters for the following Z reports are incremented when
those reports are printed.

1) General daily total report (Z1)

2) General periodic total report (Z2)

(1) Overflow mark

If the amount or quantity in any totalizer other than GT to be printed
on X or Z reports exceeds a programmed limit, the indication mark
(overflow mark) is printed for the totalizer concerned.
The overflow mark may be printed even if a totalizer does not reach
the maximum amount. This occurs, for example, when the amount
or quantity in the totalizer gets smaller than the maximum amount
due to the entry of a negative amount after the overflowing of the
totalizer. This means that when the totalizer overflows once, the
overflow mark (for example,"!!") is printed.

(2) MODE TITLE

Each report printed a MODE TITLE at a header of report.
The Report Titles are as follows.

(3) Report cancel function

It can be cancelled by turned the mode switch to MGR position
while the data is printed. (In this case, the contents of memory are
not cleared.)

<Print sample of Report cancel>

(X report)

Reading

Resetting
(Z report)

KEY

Start NO.

XXXX

XXXX

End NO.

All

PLU/SUB

Resetting

Reading

CL

KEY

(Display amount)

(Display initialize)

Reading

Resetting

TL/NS

JOB#

Reading

Executing

EURO STATUS

TL/NS

JOB#

OPX report

*OPX*

OPZ report

*OPZ*

X1 report

*X 1*

Z1 report

*Z 1*

X2 report

*X 2*

Z2 report

*Z 2*

:
:

*

*

*

*

*

 

1 the report cancel symbol

123456789012345678901234