XE-A107 (serv.man3). XE-A107 Operation Manual - Sharp ECR User Guide / Operation Manual. Page 10

Read Sharp XE-A107 (serv.man3) User Guide / Operation Manual online

8
5.
 
(For.journal.printing.only)  
Paper holding
plate
Spool
 Remove the paper holding plate from the spool.
 Insert the end of the paper into the slit in the spool. 
(Press 
F
 to feed more paper if required.) 
 Wind the paper two or three turns around the spool 
shaft.
 Mount the paper holding plate onto the take-up 
spool.
 Set the spool on the bearing, and press 
F
 to take 
up excess slack in the paper.
6.
   Replace the printer cover. 
(For.receipt.printing.only)
Pass the paper end through the openings of the printer cover.  
Be very careful not to cut yourself on the manual cutter.
NOTE
 Your register can be also used as Receipt printing.
When using as Receipt printing, refer to the “Printing
Format Programming” section on page 24.
Quick.Start.Operations
In this section, how to make basic programming which you must program before starting sales 
operation and basic sales operation are explained.
Abbreviations.and.Terminology.used.in.this.manual
  Dept.:  Department; a category for merchandise classifications.  Every sales item should belongs 
to a department.
 
PLU:  Price Look Up; a category for merchandise classifications.  PLUs are used to call up 
preset prices by a code entry (1-80).
 
VAT:  Value Added Tax
 X report:  Report to read sales data
 Z report:  Report to read and reset sales data
Receipt ON/OFF function: To print or not to print receipts or journals in the REG mode.
NOTE
 • If your domestic currency decimal position is other than 2, you must change the setting.
For setting, please refer to “Miscellaneous Programming” section on page 25.
• You can continue programming (step 1 through 3 below) without printing the
programming report by not pressing
u
at each program step. However, to finish
programming, you must press
u
.
When you press
u
at the end of programming, the programming report will be printed.
On the report you can check the settings you did. Make sure that your programming is
correctly done.
For reading the report, please refer to “Checking the Programmed Machine Settings”
section on page 27.
Page of 36
Display

Click on the first or last page to see other XE-A107 (serv.man3) service manuals if exist.