Read Sharp XE-A107 (serv.man3) User Guide / Operation Manual online
44
.
■
Mode.Switch
Insert the mode key (the same key as drawer lock key) into the mode switch and move the key to
get an appropriate mode.
get an appropriate mode.
Mode key
:
Turns the display off. No operations are
possible.
REG: Permits transaction entry.
:
Permits correction after finalizing a
transaction.
X/Flash: Permits printing of sales reports and
displaying the flash reports.
Z/PGM: Permits printing and resetting of sales
reports and programming.
.
■
Display
Your cash register is equipped with a front LED (Light-Emitting Diode) display that affords easy
visibility of 9 digits for the operator during transaction.
Repeat
PLU code
Department code
Department.code: Indicates the department entered.
For example, if department 1 was
pressed, “1” would appear.
.
PLU.code: Indicates the PLU code entered.
.
Repeat: Indicates the number of times the
same department key or PLU key is
pressed repeatedly. If an entry is
repeated more than ten times, only
the last digit is displayed.
Symbols.and.figures.appearing.on.the.display:
Error:
Appears when an error is made. If this occurs during a transaction because of
an extra digit entry, simply press
an extra digit entry, simply press
l
and re-enter correctly.
Program:
Appears when the cash register is being programmed in the “Z/PGM” mode.
Finalization:.. Appears when a transaction is finalized by pressing
A
,
c
or
C
.
Subtotal:
Appears when the cash register computes a subtotal when
u
is pressed, and
also when an amount tendered is less than the total sales amount.
Change:
Appears whenever a change due amount is displayed.
Exchange:
Appears when
V
is pressed to calculate a subtotal in foreign currency.
Low.battery: Appears when the voltage of the installed batteries is under the required level.
You need to replace the batteries with new ones very soon.
No.battery:
Appears when the batteries are not installed, or the installed batteries are dead.
You must immediately replace the batteries with new ones.
NOTE
• When the department key sign is set to “minus”, a minus sign (-) appears.
• The decimal point is shown as “ ”.
• When secret code is set, “----” appears when characters are entered.
To.display.the.time.and.date
Set the mode switch to the REG position, and press
Set the mode switch to the REG position, and press
Q
once to display the time or press
Q
twice to display the date.
Press
Press
l
key to cancel the time/date display.
Click on the first or last page to see other XE-A107 (serv.man3) service manuals if exist.