XE-A102 (serv.man4). Operation Manual - Sharp ECR User Guide / Operation Manual. Page 7

Read Sharp XE-A102 (serv.man4) User Guide / Operation Manual online

5
Preparing the Cash Register
In order for your cash register to operate properly, you must reset it before programming for the
first time.  Follow this procedure.
1. Insert the mode key into the mode switch and turn the key to the REG position.
2. Insert the plug into the AC outlet.  A buzzer will sound three times.
IMPORTANT:  This operation must be performed without batteries loaded.
3. The register display should now show “
0.00”.
4. Press 
x to confirm the clock starts from “
0-00”.
5. Press 
c to cancel the time display.
Please do the following before using the register for the first time.
Step 2  Reset the Cash Register
For installing the cash register, find a stable surface near an AC outlet where the cash register will
not subject to water sources or direct sunlight, then install the register using the fixing angle
bracket provided with the register.
The fixing angle bracket prevents the register from moving when the drawer opens. By hooking the
register on the bracket, you can secure the register to the position.
Follow the procedure shown below for the installation.
How to install the fixing angle bracket
1. 
Thoroughly clean the location where the fixing angle
bracket (B) is to be placed.
2. Peel off the adhesive tape on the fixing angle bracket.
3. Hook the angle bracket onto the hook (A) that is
located at the bottom rear of the register.
4. Firmly stick the fixing angle bracket to the table
surface that you cleaned above.
How to remove the register from the fixing angle bracket
1. 
Lift up the front of the register and pull the register
towards you.
Step 1  Install the Cash Register
A
B
 A102_01(E)  05.4.18 9:06 AM  Page 5
Page of 127
Display

Click on the first or last page to see other XE-A102 (serv.man4) service manuals if exist.