XE-A102 (serv.man2). Service Manual - Sharp ECR Service Manual (repair manual). Page 5

SPECIFICATIONS

– 3 –

•  Standard equipment

: Yes (1)

•  Max. number of drawers : 1

•  The drawer consists of

:

(1) Drawer box (outer case) and drawer

(2) Money case 

(3) Coin case 

(4) Lock (attached to the drawer)

Layout:

•  Location of the lock: Front

•  Method of locking and unlocking:

To lock, insert the drawer lock key into the lock and turn it 90 degrees
counter clockwise. To unlock, insert the drawer lock key and turn it 90
degrees clockwise.

•  Key No: 301

For memory back up, the dry battery ULM-3 (3 pieces) are needed.

1.

Memory holding time:
Approx. 1 year after New dry batteries are installed.

2.

Battery exchange method:
When the low battery symbol "L" lights up, replace the batteries (3
AA) replaced by the following method;

1)  Power on the ECR.

2)  Mode switch turn to "REG" mode.

3)  Remove the OLD dry batteries (3 pieces).

4)  The nobattery symbol "

L

" light up.

5)  Insert the NEW dry batteries (3 pieces).

6)  Confirm the low battery symbol "L" and nobattery symbol "

L

" is

off.

Low battery indication will appear on the left side of display when the

battery voltage is low.

CASE 1: When sitting idle or after completion of transaction.The 

machine can indicate the low battery condition (Always)

CASE 2: Low battery indication will not appear during key opera-tions, 

but will appear after power up of the cash register.

" 0.00    " : Battery is OK. 

"L 0.00" : Low battery (You have to change the batteries.)

After finalization

"F 12.34": Battery is OK. 

"L 12.34": Low battery ("L" indicate instead of "F".)

If the user forgets to replace the battery and the battery voltage falls
below a certain level, or if a power failure occurs with no batteries

installed, the memory contents cannot be retained. The CPU judges it

as no battery and performs the master reset. In this case, all the set-
tings and registrations are cleared. If, however, the power is con-tinu-

ously supplied to the AC cord, the memory contents are retained.

Low battery : Batteries are installed, but the voltage is low. Memory

back up can be done.

No battery :  Batteries are not installed or the voltage is extremely low.

The master reset is executed when a power failure
occurs, when the batteries are not properly changed.

Low battery & No battery indication will appear at the most left position

of display when the battery voltage is low.

CASE 1: When any numeric entry & item entry is not done or just after

finalization.

The machine can indicate the battery condition. (Always)

CASE 2: When numeric entry or item entry is done.

Battery condition is not appeared.

Exceptionally, at the power is restored after power failure, the

low battery & No battery indication will appear on the display
only when the battery voltage is low.

And the indication will disappear after any key entry.

"   0.00" : Battery is OK.

"L 0.00" : Low battery

"

L

 0.00" : No battery 

After finalization

"F 12.34": Battery is OK.

"L 12.34": Low battery ("L" indicate instead of "F".)

"

L

 12.34": No battery ("L" indicate instead of "F".)

Size

330 (w) x 360 (d) x 

●● (h)

Material

Plastic

Bell

-

Release lever

Standard equipment: situated at the bottom

Drawer open sensor

-

Separation from the drawer

Disallowed

Separation of the bill compartments from the coin
compartments

Allowed

Bill separator

-

Number of compartments

4B/5C (U)

3B/6C (V)

4B/5C (U)

3B/6C (V)

L

L