Read Sharp UP-800 (serv.man30) User Guide / Operation Manual online
9
Printer
The POS terminal UP-820F may be configured with multiple types of printers offered by the
market. For specific instructions related to the handling and care of the printer, please refer to
the applicable printer instruction manual.
market. For specific instructions related to the handling and care of the printer, please refer to
the applicable printer instruction manual.
The built-in printer is a 2 station (receipt/journal) type
thermal printer, and therefore it does not require any type
of ink ribbon or cartridge. The average life of the printer is
approximately 5 million lines.
thermal printer, and therefore it does not require any type
of ink ribbon or cartridge. The average life of the printer is
approximately 5 million lines.
To open the printer cover, lift up the cover as shown on
the right sketch.
the right sketch.
Your register is shipped with the print head release lever
held by a white retainer in the lifted up position. Be sure
to remove this retainer (see the figure at the right) and
push down the print head release lever before you use
the POS terminal.
held by a white retainer in the lifted up position. Be sure
to remove this retainer (see the figure at the right) and
push down the print head release lever before you use
the POS terminal.
Print head release lever
The print head can be lifted by the green
lever on the right side of the printer.
Pulling the lever forward lifts the print
head up. If the paper becomes jammed,
open the cutter unit pushing the cutter
open tab, then pull the lever further
forward to open the print head wider so
you can remove the jammed paper.
The print head can be lifted by the green
lever on the right side of the printer.
Pulling the lever forward lifts the print
head up. If the paper becomes jammed,
open the cutter unit pushing the cutter
open tab, then pull the lever further
forward to open the print head wider so
you can remove the jammed paper.
Cutter open tab
If a paper jam occurs, pull the cutter unit
open while pushing the cutter open tab.
Then remove the paper jam inside the
printer. For the detailed procedures, refer
to the “Removing a paper jam” section in
the “Operator Maintenance” chapter.
If a paper jam occurs, pull the cutter unit
open while pushing the cutter open tab.
Then remove the paper jam inside the
printer. For the detailed procedures, refer
to the “Removing a paper jam” section in
the “Operator Maintenance” chapter.
Do not attempt to remove the paper roll with the head in the down position. This may result in
damage to the printer and print head.
NOTE
NOTE
Printer cover
Retainer
Cutter open tab
Cutter unit
Print head release lever
Paper chute
Paper roll location
Take-up spool
Click on the first or last page to see other UP-800 (serv.man30) service manuals if exist.