Read Sharp GENERAL (serv.man17) Service Manual online
UP-R01CK
Replacing clerk key (for UP-5900)
– 2 –
2. Replacing clerk key (for UP-5900)
Remove the top cabinet according to descruotion of the UP-5900 installation MANUAL.
1) Remove the connector of a clerk key
1
, Remove the two screws
2
, and remove the clerk key unit.
Remove the screw
3
and remove the clerk key.
2) Attach the contactless key to the plate with screw
1
. Attach the
contactless key unit to the lower cabinet with screws
2
, and set the
connector
3
and attach the cable clamp with screw
4
.
(The cable should be between two bosses
B
.)
Attach the upper cabinet, attach the lid
5
, and attach the cap
6
tightly.
Note: The peojection
A
side of the lid
5
should be upper side.
Note: In case contactless key attaches, be sure to attach CE-Mark label
(accessories) to a bottom cabinet.
Using contactless key of the product with which CE-Mark is not
attached is forbidden by law.
Refer to the following figure for the attachment position of CE-Mark.
Refer to the following figure for the attachment position of CE-Mark.
2
1
3
2
1
4
3
6
5
A
B
****
Click on the first or last page to see other GENERAL (serv.man17) service manuals if exist.