Read Sharp ER-A610 (serv.man5) Service Manual online
Delete of non-accessed EAN/UPC:
[DELETE];
X1/Z1 mode
Delete of non-accessed Customer code:
[CUST]
→
[DELETE] ; X2/Z2 mode
∗
At this operation, the deleted EANs or Customer data are printed.
Stop of printing reports:
The printing of all reports can be stopped by the following operation.
The printing of all reports can be stopped by the following operation.
Changing of Receipt switch during printing reports.
ON
ON
→
OFF or OFF
→
ON
Note) When the printing is stopped, the consecutive number or Z
counter don’t return to the original value.
When Z reports, Memory is not reset.
In In-line system, when Master has consolidated the data from
the satellite, ECR can stop the printing.
When Z reports, Memory is not reset.
In In-line system, when Master has consolidated the data from
the satellite, ECR can stop the printing.
∗
1 X1: Daily X report
X2: Periodic X report
Z1: Daily Z report
X2: Periodic Z report
X2: Periodic Z report
∗
2 The time interval range, PLU code, or customer code range can
be specified by entering the start and end numbers according to
the following procedure. When specifying a single time interval,
PLU code, the start number has only to be entered.
the following procedure. When specifying a single time interval,
PLU code, the start number has only to be entered.
In case of Job#285
∗
3 When 2 is entered in the third digit of a job code, periodic reports
are printed.
Example: Daily general report; job code 100
Example: Daily general report; job code 100
Periodic general report; job code 200
∗
4 (Pick-up reports from EAN/D-EAN items)
Those reports asterisked (
∗
4) in the above list can pick up some
EAN data which you want to watch from EAN or D-EAN file.
•
An individual report is printed on the receipt and journal when the
TL key is pressed.
TL key is pressed.
•
Pressing the decimal point key just after the enery of a job code
clears the corresponding data in the ECR. (Z report)
(When printing those reports for which no Z reports can be taken,
the decimal point key cannot be pressed after the entry of a job
code.)
clears the corresponding data in the ECR. (Z report)
(When printing those reports for which no Z reports can be taken,
the decimal point key cannot be pressed after the entry of a job
code.)
•
When the decimal point key is not pressed after the entry of a job
code, the corresponding data is held in the ECR. (X report)
code, the corresponding data is held in the ECR. (X report)
XXXXXXXXXXXXX
All
X
Start No.
XXXXXXXXXXXXX
End No.
XXXXXXXXXXXXX
X
Start No.
XXXXXXXXXXXXX
End No.
Scanning
Scanning
XXXXXXXXXXXXX
X
EAN No.
TL
Pick up (to the number of records in Pick-up file)
(Scanning)
X
TL
: Previous pick-upped EAN codes
TL
: All EAN data
54
Click on the first or last page to see other ER-A610 (serv.man5) service manuals if exist.