Read Sharp ER-A410 / ER-A420 SCANNING (serv.man3) Service Manual online
System Presets
Designs and specification are subject to change without notice Page 9
Procedure B:
1) Remove the AC power cord from the outlet
2) Place the mode switch to the SRV position
3) Depress and hold the [JOURNAL] & [RECEIPT] feed keys
4) Replace the AC power cord into the wall outlet
***The operator display will show the fixed function keys (starting with the [0] key)
5) Program the Function Keys by depressing the desired location(s).
6) Once the [CA/AT] key is placed on the keyboard, ***MRS*** will be displayed and the reset
1) Remove the AC power cord from the outlet
2) Place the mode switch to the SRV position
3) Depress and hold the [JOURNAL] & [RECEIPT] feed keys
4) Replace the AC power cord into the wall outlet
***The operator display will show the fixed function keys (starting with the [0] key)
5) Program the Function Keys by depressing the desired location(s).
6) Once the [CA/AT] key is placed on the keyboard, ***MRS*** will be displayed and the reset
process will continued as outlined in Master Reset-1
Note:
***Procedure A must be used to reset the hardware. Procedure B cannot reset the hardware.
2.
Program Reset:
The Program Reset (sometimes referred to as a “Service Reset”) may be achieved with or without
a [SRV] key (part no. LKGiM7113RCZZ) based on the System Preset settings.
1. General Rule:
A Program Reset should be performed under the following general conditions:
1) After the memory allocation setting has been modified
2) When a device assignment has been modified in COM port assignment
2) When a device assignment has been modified in COM port assignment
IMPORTANT NOTE:
During the Program Reset operation, PROGRAM RESET*** is printed on the journal tape
Follow the below procedure when you wish to perform a program-reset (initialization)
2. Procedures:
Base on the SRV Job#928-B setting, there may be 3 possible procedures in performing a
Program Reset.
Procedure- A:
1) Place the mode switch to the SRV’ position
2) Place the AC power cord into the wall outlet
3) Turn the mode switch from SRV’ -- > SRV position
Click on the first or last page to see other ER-A410 / ER-A420 SCANNING (serv.man3) service manuals if exist.