DV-RW360H (serv.man9). Pages 1-25 - Sharp DVD User Guide / Operation Manual. Page 15

15

EN

•  If the external equipment connected to the Scart terminal (AV2) supplies control voltage to this unit via Pin 8 of the 

Scart cable, the display functions of the remote control cannot be seen on the TV. In this case, turn off the external 
equipment to prevent control voltage, or make sure to use a Scart cable without Pin 8 for this connection.

•  The AV2 (DECODER) connection is useful for playing back the picture only.

Even if an external equipment such as a DVD player can be delivered an RGB signals and your TV accepts them, this 
unit only records a Composite video signal.

This unit has three input terminals, AV1 or AV2 on the rear panel and AV3 on the front panel. Be sure that all the units 
are off before making connections.

If no S-Video input jack is available, connect to VIDEO input jack on the front panel by using an RCA Video cable.
Change the setup when using S-INPUT jack. (See page 36.)

AV output jack 

(Scart)

Scart cable 

(commercially available)

S-VIDEO 

OUT 

AUDIO 

OUT 

S-Video cable 

(commercially available)

Audio cable 

(commercially available)

•  The unit is sending each video signals simultaneously. If you connected an S-VIDEO OUT and/or a COMPONENT 

VIDEO OUT with the VIDEO OUT (SCART), make sure your TV’s input mode is set correctly according to the 
connection you made.

•  You will not be able to hear all of the sound being output by the unit if you use the Audio cables (commercially 

available) to a monaural TV that has only one Audio input jack.

•  Be sure that the colours of the jacks and plugs match up when connecting the cable.
•   If you want to listen to the audio through audio equipment, connect only the S-video or Component video cable to the TV.
•   The S-VIDEO OUT and COMPONENT VIDEO OUT jacks are only useful in DVD mode.
•  If your TV is compatible with 525 or 625 progressive scanning and you want to enjoy that high quality picture, 

you must connect the Component video cable to your TV’s component Video input jacks (Y/P

R

/P

B

) and select 

progressive scanning mode. To set the mode, set “Video Out” to “Component Progressive (P)” in the “Video” of the 
“Playback” menu so that “P.SCAN” will appear on the display of this unit. See pages 83-84 for more details.

•  If your TV is not compatible with progressive scanning, use this unit in interlace mode. Make sure that no “P.SCAN” 

is on the display of this unit. If so, set “Video Out” to “Component Interlace (I)” in the “Video” of the “Playback” 
menu so that “P.SCAN” on the display of this unit will disappear.

•  (Analogue) AUDIO OUT jacks and Scart terminal are not available on the DTS audio.

•  If you prefer better picture quality for the recordings from the external equipment, S-video connections such as 

AV3 (front) is recommended.