DV-RW360H (serv.man7). Pages 76-100 - Sharp DVD User Guide / Operation Manual. Page 7

82

EN

Select a setting using [Cursor K / L], then press [ENTER].
Your setting is activated.
PCM: 

  Converts the Dolby Digital into PCM (2 channel). 

If your amplifier / decoder is NOT compatible with Dolby 
Digital, set to “PCM”.

Stream:    Outputs Dolby Digital signals. 

If your amplifier / decoder is compatible with Dolby Digital, set 
to “Stream”.

Select a setting using [Cursor K / L], then press [ENTER].
Your setting is activated.
48kHz:  If your amplifier / decoder is NOT compatible with 96kHz PCM, 

select “48kHz”. Sound recorded at 96kHz is down sampled to 
48kHz.

96kHz:  If your amplifier / decoder is compatible with 96kHz PCM, select 

“96kHz”. Sound is sampled at 96kHz.

When playing back a disc with copyright protection or virtual 
surround system on this unit is set to “ON”:
•  Even if you select “96kHz”, the sound is down sampled to 48kHz.

When playing back a DVD-RW disc recorded in VR mode:
•  If the audio source on a disc is in Dolby Digital format, set “Dolby 

Digital” to “PCM” so that you can switch to main audio (L), sub 
audio (R), or a combination of both (L / R) using your amplifier / 
decoder.

Select a setting using [Cursor K / L], then press [ENTER].
Your setting is activated.
PCM:  

 Converts MPEG into PCM. 
If your amplifier / decoder is NOT compatible with MPEG, set to 
“PCM”.

Stream:   Outputs MPEG Audio signals. 

If your amplifier / decoder is compatible with MPEG, set to 
“Stream”.

Select a setting using [Cursor K / L], then press [ENTER].
Your setting is activated.
ON:  

 Outputs DTS signals. 
If your amplifier / decoder is compatible with DTS, set to “ON”.

OFF:  

 No DTS signal is output. 
If your amplifier / decoder is NOT compatible with DTS, set to 
“OFF”.