DV-RW360H (serv.man7). Pages 76-100 - Sharp DVD User Guide / Operation Manual. Page 16

91

EN

The power does not turn on.

• Check the mains cable is connected securely.
• Check the breaker (in case of power failure).

Any of the buttons on the front 
panel does not function.

• Check if the Child Lock is activated. (See page 10.)

There is no picture.

• Check signal cables are connected securely.
• Check if a connecting cable is damaged.
• Check connections to your TV. (See pages 14-15.)
• Switch the input selector on your TV (to “AV1” for example) until a picture 

appears on the screen.

The picture on your TV is distorted 
during the unit is turned on.

• Turn the unit off if the unit is not being used.
• Change the channel on this unit.

TV programme picture does not fill 
the screen.

• Set channels with “Auto Tuning” from the Setup menu. (See page 19.)
• Select the channel of a TV programme using [PROG.   /  ].

TV programme pictures are 
distorted.

• Adjust the direction of the TV antenna.
• Adjust the picture. (See the TV instruction manual.)
• Place the antenna and the TV farther apart.
• Separate any bunched antenna cables and the TV.

TV channel cannot be changed.

• Switch the TV input.
• Check if the antenna cable is connected correctly. (See pages 14-15.)

The channel cannot be changed 
from the channel you are 
recording.

• Set the TV input to “TV”.

Playback picture is distorted.

• Do not bring equipment that may cause electrical interference, such as a 

cellular phone, near the unit.

The playback picture or TV 
programme from equipment 
connected through the unit is 
distorted.

• If a DVD player, VCR or tuner is connected to your TV via the unit, the 

copyprotection signal applied to some programmes could affect picture 
quality. Disconnect the playback equipment in question and connect it 
directly to your TV.

Nothing was recorded even 
though you set the timer setting 
correctly.

• There was a power failure during recording.
• The unit’s internal clock stopped due to a power failure that lasted for more 

than 1 hour.

• Reset the clock. (See page 22.)
• Unplug the mains cable from the AC outlet and plug it in again.
• The programme contains copy protection signals that restrict copying.
• The timer setting overlapped with another setting that was set later or has priority.

WARNING
Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do 
not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair.

The following conditions do not always denote trouble. Therefore, perform the checks described below 
before calling for service. If the problem cannot be corrected by the use of this guide, remove the main 
plugs from the wall socket, and contact the dealer or supplier from whom the unit was purchased in order 
to obtain service. Where this is not possible please visit our web-site
www.sharp.co.uk/customersupport.
Customers without Internet access may telephone 08705 274277 during office hours (or (01) 6760648 if 
telephoning from Ireland), Certain replacement parts and accessories may be obtained from our main 
parts distributor, who can be contacted on the following numbers:

WILLOW VALE ELECTRONICS LTD.:

0121 766 5414

In the unlikely event of this equipment requiring repair during the guarantee period, you will need to 
provide proof of the date of purchase to the repairing company. Please keep your invoice or receipt, 
which is supplied at the time of purchase.