DV-HR400H (serv.man4) - Sharp DVD User Guide / Operation Manual. Page 114

• You can set this to enjoy LPCM, Dolby Digital sound, DTS or MPEG

sound when connecting with digital input compatible device using
Digital cable.

• Select the appropriate option.
• Select “AUTO” usually.
• If your amplifier/decoder is NOT compatible with 96kHz LPCM, select

“48kHz”. 96kHz sound will be output in 48kHz.

• If your amplifier/decoder is compatible with 96kHz LPCM, select

“96kHz”. 96kHz sound will be output.

When playing disc with copyright protection
•  If you select “AUTO”, the sound will be down sampled at 48kHz.
•  If you select “96kHz”, no digital sound will be output (only analogue

sound will be output). Select “AUTO”, so that outputting 48 kHz digital
sound.

• Setting as “PCM” converts the Dolby Digital into PCM (2 channel).

When your amplifier/decoder is NOT compatible with Dolby Digital,
set to “PCM”.

• Setting as “BITSTREAM” outputs Dolby Digital signals. When your

amplifier/decoder is compatible with Dolby Digital, set to
“BITSTREAM”.

When playing a DVD-RW disc recorded in VR mode
•  If the audio source on a disc is Dolby Digital format, set “Dolby

Digital” to “PCM” so that you can switch to main audio (Lch), sub
audio (Rch) or a mix of both (Lch+Rch) with your amplifier/decoder.

• Setting as “BITSTREAM” outputs DTS signals. When your amplifier/

decoder is compatible with DTS, set to “BITSTREAM”.

• Setting as “OFF” outputs NO DTS signals. When your amplifier/

decoder is NOT compatible with DTS, set to “OFF”.

• To play back multi-channel audio with an amplifier with decoder,

select “BITSTREAM”.

• To play back 2 channel  audio with an amplifier without decoder,

select “PCM”.

• This lets you adjust the range between the loudest and softest sound

(dynamic range), and play back at the average volume. Use this
when it is hard to hear dialogue.
NO:

This outputs recorded audio as is.

YES*:

This raises the average volume when playing back
Dolby Digital audio so that the volume sounds the same
as an audio CD. (If the audio sounds abnormal, set to
“NO”.)

* Lower the volume before setting. If you do not do so, the speaker

may emit a loud sound, or excessive input may be applied to the
speaker.

• This lets you operate the connected digital camcorder from the

Recorder when capturing video into the Recorder via a DV connec-
tion. You can also select the type of audio to be captured from the
camcorder.

NO
YES

AUTO
96kHz
48kHz

BITSTREAM
PCM

BITSTREAM
OFF

BITSTREAM
PCM

HR480H-107-116

05.3.23, 5:10 PM

112