Read Sharp DV-620 (serv.man2) Service Manual online
DV-620H
DV-620S
DV-620S
10
16.Remove the spacer (M).
*The spacer is bonded with both-side sticking tape.
17.Remove two screws, (N) of the decorative leg.
18.Push out the middle pin (O) of the setting leg in the direction
opposite to insertion (two places).
19.Remove one washer (P) and one nut (Q) which install the shuttle
knob.
20.Remove two screws (R) which install the power key PWB of the
front panel.
21.Remove three screws (S) which install the operate PWB of the
front panel.
11.Remove four screws (G).
12.Remove two screws (H), and remove the terminal of 21pin,
remove two connectors m , n .
13.Remove two screws (I) on both sides of the terminal angle frame.
14.Remove three screws (J) and release three hooks (K) which
install the terminal/power PWB.
15.Remove two screws (L) which install the display PWB.
f
f
m
n
m n
(I)x2
(K)x3
(J)x3
(L)x2
(G)x4
(H)x2
Terminal
Angle Frame
Angle Frame
Scart PWB
Display PWB
Terminal/Power
PWB
PWB
(S)x3
(P)x1
(Q)x1
(R)x2
(M)x1
(N)x2
(O)x2
Power Key PWB
Operate PWB
Click on the first or last page to see other DV-620 (serv.man2) service manuals if exist.