DV-600H (serv.man5) - Sharp DVD User Guide / Operation Manual. Page 51

The following problems do not always denote a broken DVD player.
Perform the checks listed below before calling service.

• No power

• The player is switched on but does

not operate.

• The playback image does not

appear.

• The remote control does not work.

• The sound is not Dolby Digital

(5.1ch).

• The image and sound are garbled.

• A function is disabled.

• Is the power lead connected properly?

• Is the power lead firmly plugged into the power outlet?

• One of the safety mechanisms may be operating. In this event,

unplug the player from the power outlet briefly and then plug it in
again.

• Have you loaded a disc?

• Is the disc unplayable? (See pages 4 – 8.)

• Is there condensation in the player? (See page 4.)
• Are the video and audio leads connected correctly? (See pages

10, 12 – 14.)

• Is the disc scratched? (See page 7.)

• Is the disc dirty? (See pages 7 and 50.)

• Is the disc loaded upside down?

• Is the input selector on the TV set to “VIDEO” or “AV”?

• Is the audio equipment switched on and are all the components

connected properly? (Refer to the manuals for your audio equip-
ment.)

• Are the batteries loaded correctly?

• Are the batteries flat?

• Is the signal emitter on the remote control pointing at the player?

• Is the remote control too far from the player, or is there any

obstacle between the remote control and the player?

• Is the disc you are playing recorded in Dolby Digital?

• Did you use the AUDIO button to select Dolby Digital sound?

(See page 41.)

• Is the disc scratched? (See page 7.)

• Are vibrations from the speakers affecting the player?
• Certain functions are prohibited on some DVD discs.

• Refer to the information in the disc jacket for details.

This unit is equipped with a microprocessor. Its performance could be adversely affected by external electrical
noise or interference. If this should happen, unplug the DVD player and plug it in again after a few minutes.

• When the player is connected to an amplifier with a 5.1ch input connector, the volume of the Dolby Surround

sound is lower than that of the Dolby Digital (5.1ch) sound. Adjust the volume on the amplifier.

The following conditions do not always denote trouble. Therefore, perform the checks described below
before calling for service. If the problem cannot be corrected by the use of this guide, remove the mains
plugs from the wall socket, and contact the dealer or supplier from whom the unit was purchased in order to
obtain service. Where this is not possible please contact the telephone number listed below. You will then be
given details of how to obtain service.

0345-125387

Please note: All calls will be charged at local rate.
Certain replacement parts and accessories may be obtained from our main parts distributor, who can be
contacted on the following numbers:

W

ILLOW

 V

ALE

 E

LECTRONICS

 L

TD

.

MANCHESTER 0161-682-1415

READING 01189 876444

In the unlikely event of this equipment requiring repair during the guarantee period, you will need to provide
proof of the date of purchase to the repairing company. Please keep your invoice or receipt, which is
supplied at the time of purchase.