Read Sharp DV-560H (serv.man2) Service Manual online
DV-560H
2. Remove two screws (B).
3. Remove one screw (C).
4. Release the hooks of the front panel at two places on both sides
and at three places on the bottom, and slide the front panel toward
you.
5. Disconnect the connectors (D) and (E).
6. Remove four screws (F) which installs the mechanical unit.
(W)
(X)
(T) x2
Volume PWB
LED PWB
Operate PWB
(U) x2
(V) x3
7. Disconnect the lead lines (G) and (H) and (J) from the main PWB
under the mechanism.
8. Remove two screws (K) on both sides of the terminal angle frame.
9. Remove three screws (L) which install the terminal/power PWB.
10. Remove seven screws (M) and one screw (N) which install the
terminal block.
11. Remove two screws (P) of the display PWB.
12. Remove two screws (Q) of the decorative leg.
13. Push out the middle pin (R) of the setting leg in the direction
opposite to insertion. (Two places)
14. Remove two screws (S) which install the main PWB under the
mechanical unit.
15. Remove two screws (T) which install the volume PWB of the
front panel.
16. Remove the LED PWB and two holder screws (U).
17. Remove three screws (V) which install the operate PWB.
* The spacer and insulation seat under the indication tube of (W)
and (X) are bonded with both-side sticking tape.
Top Cabinet
(A) x2
1
(A)
2
(A) x2
1
6. DISASSEMBLY AND REPLACEMENT OF MAIN PARTS
6-1. DISASSEMBLY
1. Remove five screws (A), and remove the cabinet.
Note: When assembling it, tighten the screws in order of 1 - 2 .
(Because the set may rise a little by tightening the screws.)
6-1
(F) x4
(D)
(B) x2
(E)
Screw x3
Front panel
Screw x2
(C)
(L)
(S)
(S)
(G)
(H)
(J)
(L)
(P) x2
Mechanism
Main PWB
Display PWB
Terminal/
Power PWB
Power PWB
21-Pin
Euro-SCART PWB
Euro-SCART PWB
(Q) x2
(R) x2
(N)
(M) x7
(L)
(K) x2
Click on the first or last page to see other DV-560H (serv.man2) service manuals if exist.