XL-DAB151PHBK (serv.man2) - Sharp Audio User Guide / Operation Manual. Page 25

11/8/1

01_XLDAB151PH EN_UK.fm

The connection lead is not included. Purchase a
commercially available lead as shown below.

Note:
To prevent noise interference, place the unit away from the 
television.

● Do not turn the volume on to full at switch on and listen

to music at moderate levels. Excessive sound pressure
from earphones and headphones can cause hearing
loss.

● Before plugging in or unplugging the headphone,

reduce the volume.

● Be sure your headphone has a 3.5 mm (1/8") diameter

plug and impedance between 16 and 50 ohms. The
recommended impedance is 32 ohms.

● Plugging in the headphone disconnects the speakers

automatically. Adjust the volume using the VOLUME
control.

Many potential problems can be resolved by the owner
without calling a service technician.
If something is wrong with this product, check the following
before calling your authorised SHARP dealer or service
centre.

■ Listening to the playback sounds of 

Use a connection lead to connect the portable audio
player etc. to the AUDIO IN socket. When using video
equipment, connect the audio output to this unit and the
video output to a television.

Press the ON/STAND-BY button to turn the power on.

Press the AUDIO/LINE (INPUT) button on the remote
control or FUNCTION button repeatedly on main unit to
select AUDIO IN function.

Play the connected equipment. If volume level of the
connected device is too high, sound distortion may
occur. Should this happen, lower the volume of the
connected device. If volume level is too low, increase the
volume of the connected device.

■ Headphones

Audio cable (not supplied)

Portable audio 
player, etc.

■ General

● The clock is not set 

to the correct time.

● Did a power failure occur?

Reset the clock. (Refer 
page 8 - 9)

● When a button is 

pressed, the unit 
does not respond.

● Set the unit to the power 

stand-by mode and then 
turn it back on.

● If the unit still malfunctions, 

reset it. (Refer page 25)

● No sound is heard.

● Is the volume level set to 

“Min”?

● Are the headphones 

connected?

● Are the speaker wires 

disconnected?

■ CD player

● Playback does not 

start.

● Playback stops in 

the middle or is not 
performed properly.

● Is the disc loaded upside 

down?

● Does the disc satisfy the 

standards?

● Is the disc distorted or 

scratched?

● Playback sounds are 

skipped, or stopped 
in the middle of a 
track.

● Is the unit located near 

excessive vibrations?

● Is the disc very dirty?

● Has condensation formed 

inside the unit?

■ Remote control

● The remote control 

does not operate.

● Is the AC power lead of the 

unit plugged in?

● Is the battery polarity 

correct?

● Are the batteries dead?

● Is the distance or angle 

incorrect?

● Does the remote control 

sensor receive strong 
light?

■ Tuner

● The radio makes 

unusual noises 
continuously.

● Is the unit placed near the 

TV or computer?

● Is the DAB/FM aerial 

placed properly? Move the 
aerial away from the AC 
power lead if it is located 
nearby.