Read Sharp SD-NX10 (serv.man5) Service Manual online
– 21 –
SD-NX10H
How to remove CD spindle motor
(See Fig. 21-1 and 21-2)
(See Fig. 21-1 and 21-2)
1. Remove the stop washer (C1) x 1, metal fitting (C2) x 1,
spring (C3) x 1, and another metal fitting (C4) x 1.
2. Remove the screws (C5) x 2 pcs.
3. Move the unit in the direction indicated by the arrow to take
3. Move the unit in the direction indicated by the arrow to take
it out.
4. Remove the screws (C6) x 2 pcs., and remove the CD
spindle motor.
Figure 21-1
(C4)x1
(C2)x1
(C1)x1
(C3)x1
(C5)x2
ø2x4mm
Figure 21-2
(C6)x2
ø1.6x2mm
CD Spindle
Motor
How to remove CD loading motor
(See Fig. 21-3)
(See Fig. 21-3)
1. Remove the screws (D1) x 4 pcs.
2. Remove the springs (D2) x 2.
3. Remove the fitting (D3) x 1.
4. Pull out the CD loading motor in the direction indicated by
2. Remove the springs (D2) x 2.
3. Remove the fitting (D3) x 1.
4. Pull out the CD loading motor in the direction indicated by
the arrow.
Figure 21-3
Pull
(D1)x1
ø2x2.6mm
(D1)x1
ø2x2.6mm
(D1)x2
ø2x2.6mm
(D2)x1
(D2)x1
(D3)x1
How to eject CD unit (See Fig. 21-4)
1. Unsolder the loading motor lead wire, connect the black
lead wire to + and red lead wire to GND, and apply +5V to
eject the CD unit.
eject the CD unit.
Figure 21-4
CD Servo PWB
+5V
Connection
Black
GND
Connection
Red
How to reassemble CD mechanism unit
(See Fig. 21-5)
(See Fig. 21-5)
1. Lift the gear block (E1) x 1.
2. Insert the mechanism block (E2) x 1 into the mechanism
2. Insert the mechanism block (E2) x 1 into the mechanism
chassis (E3) x 1.
3. Engage the gear properly and place it.
Figure 21-5
(E2)x1
(E1)x1
(E3)x1
Click on the first or last page to see other SD-NX10 (serv.man5) service manuals if exist.