Read Sharp SD-EX220 User Guide / Operation Manual online
E-9
SD-EX220H
ENGLISH
SD-EX220H(H)_E.fm
03/6/9
TINSZ0953AWZZ
Prepar
ation for
Us
e
-
T
o
i
n
st
all t
h
e m
a
in
u
n
it
an
d
sp
e
ake
rs o
n
t
h
e w
a
ll -
To install the main unit and speakers on the wall
CAUTION:
! Be very careful to prevent the main unit [3.7 kg (8.2 lbs.)] from falling when mount-
ing on the wall.
! Before mounting, check the wall strength. (Do not put to the veneer plaster or
whitewashed wall. The main unit or speakers may fall.) If it is not clear, consult
with a qualified service technician.
with a qualified service technician.
! Mounting screws are not supplied. Use appropriate ones.
! Check all mounting screws for looseness and that they are engaged in the main
! Check all mounting screws for looseness and that they are engaged in the main
unit and speakers.
! Mount the main unit and speakers on the wall with 2 screws for each.
! Select a good location. If not, accidents may occur or the unit may get damaged.
! Avoid placing on a bed, sofa, water tank, sink and hallway wall.
! To avoid accidents, fix the speaker wires to the wall. You may trip over them.
! SHARP is not responsible for accidents resulting from improper installation.
! Select a good location. If not, accidents may occur or the unit may get damaged.
! Avoid placing on a bed, sofa, water tank, sink and hallway wall.
! To avoid accidents, fix the speaker wires to the wall. You may trip over them.
! SHARP is not responsible for accidents resulting from improper installation.
" Driving screws
Sharp designed the main unit and speakers so you may hang them on the wall.
Use proper screws (not supplied). See below for size and type.
Use proper screws (not supplied). See below for size and type.
" Installing the main unit
1
Make a hole in the wall using a drill.
2
Drive a wall mount plug into the hole using a hammer, until it is
flush with the wall surface.
flush with the wall surface.
5 mm (3/16")
3.2 mm (1/8")
Min. 22 mm (7/8")
9 mm (3/8")
32 mm (1-1/4")
8-9 mm (3/8")
3
Drive two screws into the wall for main unit and each speaker, as
shown in the illustration.
shown in the illustration.
! Make sure that both the screw and the wall can support a load of 20 kg (45
lbs.).
! Drive the screws, so the screw head extends about 5.5 mm (7/32") out from
the wall.
1
Fix the pattern paper and drive two screws into the wall with a dis-
tance of 160 mm (6-5/16") in between.
tance of 160 mm (6-5/16") in between.
2
Tighten the screws and remove the paper. Hook the main unit on
the screw heads and make sure it is secure.
the screw heads and make sure it is secure.
Put the left speaker wire in the groove on the back of the main unit.
Wall mounting screw
Wall surface
Wall surface
5.5 mm (7/32")
Pattern paper
for main unit
for main unit
160 mm (6-5/16")
Wall surface
Speaker wire
Click on the first or last page to see other SD-EX220 service manuals if exist.