QT-CD141H - Sharp Audio User Guide / Operation Manual. Page 10

– 10 –

  1. Tuner

(  ): AM mode
Marking except for (  ): FM mode

2. CD

(  ): Play mode
Marking except for (  ): Stop state

3. Deck section

(  ): Record mode
Marking except for (  ): Playback mode
Display / Control section:
(  ): Active state
Marking except for (  ): CD Function mode at stop state

• Schematic diagram and Wiring Side of P.W.Board for this

model are subject to change for improvement without prior
notice.

• Parts marked with “      ” (

          ) are important for

maintaining   the safety of the set. Be sure to replace these
parts with specified ones for maintaining the safety and
performance of the set.

• Resistor:

To differentiate the units of resistors, the symbol as K and M
are used: the symbol K means 1000 ohm and the symbol M
means 1000 kohm and the resistor without any symbol is an
ohm resistor. The resistor designated "Fusible" is a fuse type
resistor

• Capacitor:

To indicate the unit of capacitor, a symbol P is used: this
symbol P means micro-micro-farad and the unit of the capacitor
without such a symbol is microfarad. As to electrolytic capacitor,
the expression “capacitance/withstand voltage” is used.
(CH), (TH), (RH), (UJ): Temperature compensation
(ML): Mylar type
(P.P.): Polypropylene type

• The indicated voltage in each section is the one measured by

Digital Multimeter between such a section and the chassis
with no signal given.

SW102

RECORD/PLAYBACK

PLYBACK—RECORD

SW201

FUNCTION/POWER

TAPE—TUNER— CD/
OFF—ON

SW202

X-BASS

OFF—ON

SW203

SURROUND(162H ONLY)

OFF—ON

SW501

TUNER UP

OFF—ON

SW502

TUNER DOWN

OFF—ON

SW503

BAND

OFF—ON

SW504

MEMORY

OFF—ON

SW505

PRESET DOWN

OFF—ON

SW506

PRESET UP

OFF—ON

SW507

CD LID OPEN/CLOSE

OFF—ON

SW601

TAPE MAIN

OFF—ON

SW702

PICKUP IN

OFF—ON

KTA1266 GR
KTA1273 Y
KTC3194 Y
KTC3199 GR
KTC8050 D
KRA102 M
KRA109 M
KRC104 M
KRC107 M

FRONT

VIEW

E  C  B

(S)(G)(D)

(1) (2) (3)