HT-SL70 (serv.man3) - Sharp Audio Service Manual (repair manual). Page 13

Read Sharp HT-SL70 (serv.man3) Service Manual online

HT-SL70
6 – 1
CHAPTER 6. CIRCUIT SCHEMATICS AND PARTS LAYOUT
[1] Notes On Schematic Diagram
[2]  Types Of Transistor And LED
Resistor:
To differentiate the units of resistors, such symbol as 
K and M are used: the symbol K means 1000 ohm 
and the symbol M means 1000 kohm and the 
resistor without any symbol is ohm-type resistor. 
Besides, the one with “Fusible” is a fuse type.
Capacitor:
To indicate the unit of capacitor, a symbol P is used:
this symbol P means pico-farad and the unit of the 
capacitor without such a symbol is microfarad. As to 
electrolytic capacitor, the expression “capacitance/ 
withstand voltage” is used.
(CH), (TH), (RH), (UJ): Temperature compensation
(ML): Mylar type
(P.P.): Polypropylene type
Schematic diagram and Wiring Side of P.W.Board 
for this model are subject to change for
improvement without prior notice.
The indicated voltage in each section is the one 
measured by Digital Multimeter between such a 
section and the chassis with no signal given.
Parts marked with “
” are important for 
maintaining the safety of the set. Be sure to replace 
these parts with specified ones for maintaining the 
safety and performance of the set.
1117Y33
(1) (2) (3)
(1)(2)(3)(4)(5)
TOP VIEW
TOP VIEW
NM3421
W
E
I
V
 
P
O
T
W
E
I
V
 
P
O
T
1N4004
TOP VIEW
DXA010
KRC104S
B
(3)
E
(1)
C
(2)
Page of 32
Display

Click on the first or last page to see other HT-SL70 (serv.man3) service manuals if exist.