Read Sharp HT-SB400H User Guide / Operation Manual online
Make sure to unplug the AC power lead before installing the speaker or changing the position.
Speaker preparation
Select from three installation methods according to the preferred position.
Using spikes
Tighten all spikes
as shown.
as shown.
Option 1
You may choose from the two different spikes
length provided:
25 mm and 30 mm.
Nuts (secured on 30 mm spikes) must be used
when installing either the 25 mm or 30 mm
spikes.
The speaker can be leveled by adjusting the
spikes and nuts.
length provided:
25 mm and 30 mm.
Nuts (secured on 30 mm spikes) must be used
when installing either the 25 mm or 30 mm
spikes.
The speaker can be leveled by adjusting the
spikes and nuts.
Option 2
Attach foot cushions as shown.
To mount the speaker on the wall
Wall surface
H
H
H
H
H
Wall mount angle fixed to the wall
(Horizontal position)
(Horizontal position)
H
H
H
H
H
Installing the speaker
1
Fix the pattern paper to the wall in
horizontal position as below.
horizontal position as below.
2
Make a hole on the wall following the
screw point marks on the pattern paper by
using a drill.
screw point marks on the pattern paper by
using a drill.
3
Fix a wall mount plug into the hole using
a hammer, until it is flush with the wall
surface.
a hammer, until it is flush with the wall
surface.
4
Screw the wall mount angle to the wall as
shown in the illustration. (Total screw is 8
pieces).
shown in the illustration. (Total screw is 8
pieces).
1
Align the wall mount slot at the speaker to
the wall mount angle.
the wall mount angle.
2
Slot the speaker into the wall mount
angle.
angle.
3
Fix them securely.
Using foot cushions
Option 1
Option 2
Wall surface
Pattern paper
29 mm
29 mm
44 mm
44 mm
509 mm
Wall surface
Wall mount angle
Wall mount angle
(screws x 4)
(screws x 4)
HT-SB400/500 QG
8/12/09, 4:55 PM
2
Display
