Read Sharp HT-SB30 User Guide / Operation Manual online
E-
System preparation
Make sure to unplug the AC power lead before in-
stalling the sound bar or changing the position.
Using spike legs (for UK and Ireland customers)
Peel the double sided tape separator.
Fix the spike leg onto the sound bar as
shown.
To mount the sound bar on the wall
Caution:
Be very careful to prevent the sound bar 2.3 kg
from falling when mounting on the wall.
Before mounting, check the wall strength. (Do not
put on the veneer plaster or whitewashed wall. The
sound bar may fall.) If unsure, consult a qualified
service technician.
Mounting screws are not supplied. Use appropri-
ate ones.
Check all wall mount angle screws for looseness.
Select a good location. If not, accidents may occur
or the sound bar may get damaged.
SHARP is not responsible for accidents result-
ing from improper installation.
Driving screws
■
SHARP designed the sound bar so you may hang
it on the wall. Use proper screws (not supplied).
See below for size and type.
3.2 mm
9 mm
22 mm
5 mm
●
●
●
●
●
●
●
Installing the sound bar
■
Fix the pattern paper to the wall in hori-
zontal position as below.
44 mm
509 mm
Wall surface
Pattern paper
(supplied)
548 mm
Make a hole on the wall following the screw
point marks on the pattern paper by using
a drill.
Wall surface
32 mm
8-9 mm
Fix a wall mount plug into the hole using
a hammer, until it is flush with the wall
surface.
32 mm
8-9 mm
Wall sur
face
3
Fasten the screws to the wall as shown below.
(Total screw is 2 pieces)
Screw using
Wall surface
Wall surface
Screwdriver
4.5 mm - 5 mm
Gap from wall
surface
Hang the sound bar onto the screws.
Bottom of
sound bar
Spike leg
Double sided
tape separator
Click on the first or last page to see other HT-SB30 service manuals if exist.