Read Sharp DK-KP85H User Guide / Operation Manual online
23
Enhancing your system
The connection lead is not included. Purchase a commercially
available lead as shown below.
Audio cable
(not supplied)
Portable
audio
player, etc.
■
Listening to the playback sounds of
portable audio player, etc.
1
Use a connection lead to connect the portable audio
player etc. to the AUDIO IN socket. When using video
equipment, connect the audio output to this unit and
the video output to a television.
2
Press the ON/STAND-BY button to turn the power on.
3
Press the AUDIO IN button on the remote control or
FUNCTION button repeatedly on main unit to select
AUDIO IN function.
4
Play the connected equipment. If volume level of the
connected device is too high, sound distortion may
occur. Should this happen, lower the volume of the
connected device. If volume level is too low, increase
the volume of the connected device.
Note:
To prevent noise interference, place the unit away from
the television.
■
Headphones
●
Do not turn the volume on to full at switch on and
listen to music at moderate levels. Excessive sound
pressure from earphones and headphones can cause
hearing loss.
●
Be sure your headphone has a 3.5 mm (1/8”) diameter
plug and impedance between 16 and 50 ohms. The
recommended impedance is 32 ohms.
●
Before plugging in or unplugging the headphone,
reduce the volume.
●
Plugging in the headphone disconnects the speakers
automatically. Adjust the volume using the VOLUME (+ or
-) on the main unit or VOL +/- on the remote control.
Troubleshooting chart
Many potential problems can be resolved by the owner
without calling a service technician.
If something is wrong with this product, check the
following before calling your authorised SHARP dealer or
service centre.
■
General
Symptom
Possible cause
●
The clock is not set to
the correct time.
●
Did a power failure occur?
●
Reset the clock. (Refer
page 21)
●
When a button is
pressed, the unit does
not respond.
●
Set the unit to the power
stand-by mode and then
turn it back on.
●
If the unit still
malfunctions, reset it.
(Refer page 24)
●
No sound is heard.
●
Is the volume level set to
“Min”?
●
Are the headphones
connected?
●
Is the unit too far from the
Bluetooth stereo audio
source device?
●
Is the unit paired with the
Bluetooth stereo audio
source device?
●
Bluetooth sound
is interrupted or
distorted.
●
Is the unit too near to a
device that generates
electromagnetic
radiation?
●
Is there any obstacle
between the unit and the
Bluetooth stereo audio
source device?
■
CD player
Symptom
Possible cause
●
Playback does not
start.
●
Playback stops in
the middle or is not
performed properly.
●
Is the disc loaded face
down?
●
Does the disc satisfy the
standards?
●
Is the disc distorted or
scratched?
●
Playback sounds are
skipped, or stopped
in the middle of a
track.
●
Is the unit located near
excessive vibrations?
●
Is the disc very dirty?
●
Has condensation formed
inside the unit?
■
Remote control
Symptom
Possible cause
●
The remote control
does not operate.
●
Is the AC power lead of the
unit plugged in?
●
Is the battery polarity
correct?
●
Is the battery dead?
●
Is the distance or angle
incorrect?
●
Does the remote control
sensor receive strong light?
Click on the first or last page to see other DK-KP85H service manuals if exist.