Read Sharp DK-AP2BK (serv.man2) User Guide / Operation Manual online
7
DK-AP2
DK-AP2(BK)
Preparation f
or Use
Using with the batteries
Battery replacement:
When batteries are low, sound becomes distorted and indicators will be
blinking. Reduce the volume level or replace the batteries with new ones.
blinking. Reduce the volume level or replace the batteries with new ones.
Battery life
Note:
Battery life may vary depending on the temperature, battery types and
usage conditions.
usage conditions.
Precautions for battery use:
Installing the batteries incorrectly may cause the unit to malfunction.
Insert the batteries according to the direction indicated in the battery
compartment.
compartment.
Remove the batteries if the unit is not to be used for long periods of
time. This will prevent potential damage due to battery leakage.
time. This will prevent potential damage due to battery leakage.
When using batteries, the brightness of all illumination light
(indicators) is reduced compared to using AC/DC adaptor.
(indicators) is reduced compared to using AC/DC adaptor.
Replace all old batteries with new ones at the same time.
Do not mix old and new batteries.
Batteries (battery pack or batteries installed) shall not be exposed to
excessive heat such as sunshine, fire or the like.
excessive heat such as sunshine, fire or the like.
Caution:
Do not use rechargeable batteries (nickeI-cadmium battery,etc.).
Changing power source:
Turn off the unit before changing the power source. If the 6V DC power
supply is directly plugged in during power on, the unit may automatically
enter to stand-by mode. Press the ON/STAND-BY button again to turn on
the unit.
supply is directly plugged in during power on, the unit may automatically
enter to stand-by mode. Press the ON/STAND-BY button again to turn on
the unit.
Remote control
Battery installation
This product contains a CR Coin Lithium Battery which contains
Perchlorate Material – special handling may apply. California residents,
see www.dtsc.ca.gov/hazardouswaste/perchlorate/
Perchlorate Material – special handling may apply. California residents,
see www.dtsc.ca.gov/hazardouswaste/perchlorate/
Precautions for battery use:
Remove the battery if the unit will not be used for long periods of time.
This will prevent potential damage due to battery leakage.
This will prevent potential damage due to battery leakage.
Caution:
Do not use rechargeable battery (nickel-cadmium battery, etc.).
Replace only with the same or equivalent type.
Installing the battery incorrectly may cause the unit to malfunction.
Danger of explosion if battery is incorrectly replaced.
Batteries (battery pack or batteries installed) shall not be exposed to
excessive heat such as sunshine, fire or the like.
excessive heat such as sunshine, fire or the like.
1
Disconnect the AC/DC adaptor, and open the battery
compartment.
compartment.
2
Insert 4 “AA” size batteries (UM-3, R6 or similar) into the battery
compartment.
“AA” size batteries (UM-3, R6 or similar) are not included.
Battery Insertion:
Slide in batteries 1
Battery Insertion:
Slide in batteries 1
1
1
1 and 3
3
3
3. Then push batteries 2
2
2
2 and 4
4
4
4
towards .
Battery removal:
Push batteries 2
Battery removal:
Push batteries 2
2
2
2 and 4
4
4
4 towards and remove the batteries before
sliding out batteries 1
1
1
1 and 3
3
3
3.
3
Close the battery compartment.
4
The STAND-BY indicator will turn red.
Remove the batteries if the unit is not to be used for long period of
time to prevent battery leakage which may cause potential damage.
time to prevent battery leakage which may cause potential damage.
Battery type
ALKALINE (AA) (1.5V)
Usage time
Approx. 8 hrs.
Output
74mW + 74mW
2
+
+
+
3
4
+
1
1 Whilst pushing the locking tab towards the centre of the remote
control, slide out the battery holder.
2
Remove the old battery from the battery holder, insert the new battery
and then slide the battery holder back into the remote control.
and then slide the battery holder back into the remote control.
Back of remote control
Locking tab
Locking tab
Positive (+) side up
Battery holder
Battery type
Polarity (+) symbol
Click on the first or last page to see other DK-AP2BK (serv.man2) service manuals if exist.