Read Sharp DK-A1H (serv.man6) User Guide / Operation Manual online
Accessories
TINSEA1
81AWZZ
07C R AS 1
System connections
MUSIC SYSTEM FOR iPod
®
Wall socket
(AC 220 - 240 V, 50 Hz)
To AC input
AM loop aerial x 1
Remote control x 1
FM aerial x 1
Turn on your system
The first time the unit is plugged in, the unit will enter the
demonstration mode.
demonstration mode.
1
Press the ON/STAND-BY button to turn the power on.
AM loop aerial
FM aerial
AC power lead x 1
iPod adaptor x 8
Before using remote control
Battery holder
Plastic shield
Remote controller
Before using remote control, please remove plastic shield at
battery holder.
battery holder.
DK-A1H
DK-A1H(BK)
DK-A1H(BK)
This quick Start Guide will help you to correctly install and
operate your system.
Illustration printed in this quick guide are for the model DK-A1H.
operate your system.
Illustration printed in this quick guide are for the model DK-A1H.
MODEL
1
Whilst pushing the locking tab towards the centre of the
remote control, slide out the battery holder.
remote control, slide out the battery holder.
2
Remove the old battery from the battery holder, insert the
new battery and then slide the battery holder back into the
remote control.
new battery and then slide the battery holder back into the
remote control.
Use the “CR 2025”, coin lithium battery.
Remote control battery installation
Back of remote control
Locking tab
Positive (+) side up
Battery holder
Polarity (+) symbol
Battery type
Locking tab
TV
Video Cable
(not supplied)
To video
input socket
DK-A1H QG
3/8/07, 3:46 PM
1
H
H
H
H
H
iPod adaptor connection
1
Push the iPod sliding door until end.
2
Insert the iPod adaptor into unit and connect your iPod.
Listening to the radio
1
Press the ON/STAND-BY button to turn the power on.
2
Press the TUNER button on main unit or FUNCTION button on remote control repeatedly to select the desired frequency
band (FM or AM).
band (FM or AM).
3
Press the TUNING (
4
4
4
4
4
or
3
3
3
3
3) button on the remote control to tune in to the desired station.
Manual tuning: Press the TUNING (
4
4
4
4
4 or 3
3
3
3
3) button as many times as required to tune in to the desired station.
Auto tuning: When the TUNING (
4
4
4
4
4 or 3
3
3
3
3) button is pressed for more than 0.5 seconds, scanning will start
automatically and the tuner will stop at the first receivable broadcast station.
H
H
H
H
H
To remove iPod adaptor
Hold this tip and pull as direction shown to remove adaptor.
H
H
H
H
H
iPod playback
1
Press the ON/STAND-BY button to turn the power on.
2
Press the iPod button on main unit once or FUNCTION button
on remote control repeatedly to select iPod function.
on remote control repeatedly to select iPod function.
3
Open the iPod terminal door and insert iPod unit in iPod dock
of main unit.
of main unit.
EQ
-
+
iPod
AUX
E SOU
N
4
Press the
0
0
0
0
0
/
6
6
6
6
6
button to start playback.
iPod
iPod adaptor
Note: For details, refer iPod adaptor table on page 14 in the
operation manual.
Listening to the iPod
EQ
-
+
iPod
AUX
EQ
-
+
iPod
AUX
E SOUN
E SOUN
E SO
UN
iPod (bottom)
Dock connector
iPod dock
iPod connector
iPod adaptor
iPod
DK-A1H QG
3/8/07, 3:46 PM
2
Display
