DK-A1H (serv.man5) - Sharp Audio User Guide / Operation Manual. Page 13

DK-A1H

DK-A1H(BK)

In this example, the clock is set for the 12-hour (12:00 AM) display.

To confirm the time display:
[When the unit is in the stand-by mode or in demonstration mode.]
Press the CLOCK button to enter the clock function.

[When the power is on]
Press DISPLAY button on the remote control to toggle between the
function information and clock display.
 
Notes:

The clock will continue counting for 8 hours should there be a
power failure or the AC power lead becomes disconnected.
The “CLOCK ADJ” will appear or time will flash to confirm the time
display when the AC power supply is restored after a power failure
or unplugging the unit after 8 hours. If incorrect, readjust the clock
as follows.

To readjust the clock:
Perform “Setting the clock” from step 1 to step 4.

Summer Time:
The Summer Time switch is located on the rear of the unit.

The 12-hour display will appear.

 

(12:00 AM - 11:59 PM)

The 12-hour display will appear.

 

(0:00 AM - 11:59 PM)

The 24-hour display will appear.

 

(0:00 - 23:59)

Press the 

 or 

 button once to advance the time by 1 hour.

Hold it down to advance continuously.

Press the 

 or 

 button once to advance the time by

1 minute. Hold it down to change the time in 5-minutes interval.

1

Clear all the programmed contents. [Refer to “Clearing all the
memory (reset)” on page 28 for details.]

2

Perform “Setting the clock” from step 1.

1

Slide the Summer Time switch to +1 to advance the
time 1 hour.

 indicator will appear.

2

Slide the Summer Time switch to -1 to turn the clock 
back 1 hour.

“12:00 AM”

“0:00 AM”

“0:00”