DK-A10H (serv.man2) - Sharp Audio User Guide / Operation Manual. Page 33

DK-A10H

DK-A10H(BK)

Many potential problems can be resolved by the owner without
calling a service technician.
If something is wrong with this product, check the following before
calling your authorised SHARP dealer or service centre.

 

Sudden temperature changes, storage or operation in an extremely
humid environment may cause condensation inside the cabinet or on
the transmitter on the remote control.
Condensation can cause the unit to malfunction. If this happens,
leave the power on with no disc until normal playback is possible
(about 1 hour). Wipe off any condensation on the transmitter with a
soft cloth before operating the unit.

When this product is subjected to strong external interference
(mechanical shock, excessive static electricity, abnormal supply
voltage due to lightning, etc.) or if it is operated incorrectly, it may
malfunction.

The clock is not set to 
the correct time.

Is the Summer Time switch set to the 
correct setting? (Refer to page 13)
Did a power failure occur? Reset 
the clock. (Refer to page 34)

When a button is 
pressed, the unit does 
not respond.

Set the unit to the power stand-by
mode and then turn it back on.
If the unit still malfunctions, reset it. 
(Refer to page 34)

No sound is heard.

Is the volume level set to “0”?
Are the headphones connected?

iPod door not fully 
open/close.

Set the unit to the power  stand-by 
and turn it on again.
Reset it. (Refer page 34)

The remote control does 
not operate.

Is the AC power lead of the unit 
plugged in?
Is the battery polarity correct?
Are the battery dead?
Is the distance or angle incorrect?
Does the remote control sensor 
receive strong light?

The radio makes unusual 
noises continuously.

Is the unit placed near the TV or
computer?
Is the FM aerial or AM loop aerial
placed properly? Move the aerial
away from the AC power lead if it
is located nearby.

Playback does not start.
Playback stops in the 
middle or does not 
perform properly.

Is the disc loaded upside down?
Does the disc satisfy the standards?
Is the disc distorted or scratched?

Playback sounds are 
skipped, or stopped in 
the middle of a track.

Is the unit located near excessive 
vibrations?
Is the disc very dirty?
Has condensation formed inside the 
unit?

No sound is produced.
No image appears on 
the TV/monitor.

The iPod is not playing.
The iPod is not properly connected 
to the unit.
Is the AC power lead of the unit 
plugged in?
The video cable is not properly 
connected.
The TV/monitor’s input selection is 
not properly set.

iPod will not charge

Wrong iPod adaptor is used.
The iPod is not making full contact 
with the iPod connector.
The main unit is in stand-by mode.