Read Sharp CD-PC671H User Guide / Operation Manual online
<P=004>
SETTING THE CLOCK
1
Press the ON/STAND-BY button to enter the stand-by mode.
2
Press the CLOCK button.
3
Within 5 seconds, press the MEMORY/SET button.
4
Press the TUNING/TIME (
X
or
W
) button to select the time
display mode.
"0:00"
→
The 24-hour display will appear.
(0:00 - 23:59)
"AM 0:00"
"AM 0:00"
→
The 12-hour display will appear.
(AM 0:00 - PM 11:59)
"AM 12:00"
"AM 12:00"
→
The 12-hour display will appear.
(AM 12:00 - PM 11:59)
●
Note that this can only be set when the unit is first installed
or it has been reset (see page 29).
or it has been reset (see page 29).
5
Press the MEMORY/SET button.
6
Press the TUNING/TIME (
X
or
W
) button to adjust the hour.
●
Press the TUNING/TIME (
X
or
W
) button once to advance
the time by 1 hour. Hold it down to advance continuously.
●
When the 12-hour display is selected, "AM" will change auto-
matically to "PM".
matically to "PM".
7
Press the MEMORY/SET button.
8
Press the TUNING/TIME (
X
o r
W
) button to adjust the
minutes.
●
Press the TUNING/TIME (
X
or
W
) button once to advance
the time by 1 minute. Hold it down to change the time in 5
minute intervals.
minute intervals.
●
The hour setting will not advance even if minutes advance from
"59" to "00".
"59" to "00".
9
Press the MEMORY/SET button.
●
The clock starts operating from "0" seconds.
(Seconds are not displayed.)
(Seconds are not displayed.)
To see the time display:
TUNING/
TIME
( )
TIME
( )
MEMORY/
SET
SET
CLOCK
ON/
STAND-BY
STAND-BY
0:00
AM 0:00
AM 12:00
2
3
4
7
6
5
8
9
Press the CLOCK button.
●
The time display will appear for about 5 seconds.
Note:
●
The clock display will flash on and off at the push of the CLOCK
button when the AC power supply is restored after a power
failure occurs or after the AC power lead is disconnected.
If this happens, follow the procedure below to change the clock
time.
button when the AC power supply is restored after a power
failure occurs or after the AC power lead is disconnected.
If this happens, follow the procedure below to change the clock
time.
To change the clock time:
①
Press the CLOCK button.
②
Within 5 seconds, press the MEMORY/SET button.
③
Perform steps 6 - 9 above.
To change the time display mode:
①
Perform steps 1 - 2 in the section "RESETTING THE MICRO-
COMPUTER", on page 29.
COMPUTER", on page 29.
②
Perform steps 1 - 9 above.
(Main unit operation)
In this example, the clock is set for the
24-hour (0:00) system.
24-hour (0:00) system.
CD-PC671H(SUK) TINSE0261AWZZ
9
Click on the first or last page to see other CD-PC671H service manuals if exist.