CD-CH1000 (serv.man25). CD changer assembly and adjustment procedures - Sharp Audio Service Manual (repair manual). Page 4

– 20 –

143

LIFT GEAR B

141
MODE BIG GEAR

133

132

104
CHANGE BOX R

147

146

128

MT IDLER GEAR F

110

Mark position

111

145

142

LIFT GEAR A

153

137

138

144
LIFT GEAR C

134

136

(A)

(B)

144
LIFT GEAR C

143

LIFT GEAR B

142
LIFT GEAR A

141
MODE BIG GEAR

Note

(Assemble the mode big gear in this position.)

To assemble the mode
big gear, incline it, 
bring it into contact with 
the circumference and 
put the center hole into 
position since the 
hatched part of the main 
base is overlapped with 
the circumference.

Direct the short tooth 
toward the center.

MODE BIG GEAR 
LIFT GEAR A/B/C 
ASSEMBLING POSITION

Scale: 2 magnifications

Scale: 2 magnifications

<Assembling method of lift gear>

After setting up the mode big gear in the 
shown position, engage it with the STB gear A
 (gear on the lower side) at the position (A), 
and assemble them, turning it in the arrow direction 
into the position (B). (The short tooth directs toward the 
center of the mode big gear.)

,,,,,,,,,,,,,,,,

,,,,,,,,,,,,,,,,

,,,,,,,,,,,,,,,,

,,,,,,,,,,,,,,,,

,,,,,,,,,,,,,,,,

,,,,,,,,,,,,,,,,

,,,,,,,,,,,,,,,,

,,,,,,,,,,,,,,,,

,,,,,,,,,,,,,,,,

,,,,,,,,,,,,,,,,

,,,,,,,,,,,,,,,,

,,,,,,,,,,,,,,,,

,,,,,,,,,,,,,,,,

,,,,,,,,,,,,,,,,

,,,,,,,,,,,,,,,,

,,,,,,,,,,,,,,,,

,,,,,,,,,,,,,,,,

,,,,,,,,,,,,,,,,

,,,,,,,,,,,,,,,,

,,,,,,,,,,,,,,,,

,,,,,,,,,,,,,,,,

,,,,,,,,,,,,,,,,

,,,,,,,,,,,,,,,,

,,,,,,,,,,,,,,,,

,,,,,,,,,,,,,,,,

,,,,,,,,,,,,,,,,