CD-BA3100 (serv.man3). Split - Section 2a - Alternative CD changer mechanical breakdown - 18-24 - Sharp Audio Service Manual (repair manual). Page 5

– 22 –

Mark position

37

°

33

32

30
TRAY DRIVE GEAR F

35
TRAY JOINT GEAR F

02
CHANGE BOX L

< Importance >
Direct the recess part
(trapezoidal side) of the
 axis 35 in this direction.

*2

*1: To position the axis part 
      of 35, engage it with 33.
*2: When it is aligned as 
      described in *1, the hatched part 
      (low gear-height part of gear) 
      will be positioned as shown.

Since this gear engagement is not 
visually checked, verify that it does 
not float when the gear box L is installed.

30
TRAY DRIVE GEAR F

35
TRAY JOINT GEAR F

*1

43

41

40
LIFT
CAM

Scale: 2 magnifications

44

11

TRAY JOINT GEAR F
(CHANGE BOX L ASS'Y) ASSEMBLING POSITION
LIFT CAM

1. Turn the mode big gear approx. 37 degrees in the arrow direction.
2. Assemble the change box L ass'y.
Note: At this time, the tray joint gear F must be located in the position shown in figure.
          Moreover, the gear must be engaged securely.

3. After assembly, return the mode big gear to the initial position.
4. Assemble the lift cam.
Note: At this time, the lift cam (No.40) must be located in the position shown in figure 22.

47

46

10

45

42

LIFT GEAR A

28

L

40
LIFT CAM

Scale: 2 magnifications

During assembly, make the 
O part visible in this direction.

Note: Among 4 ribs on the 
          circumference, one rib alone 
          is provided with O.

30
TRAY DRIVE GEAR F

35
TRAY JOINT GEAR F