Read Sharp CD-BA2010 (serv.man13) Technical Bulletin online
AUD2001 11 04
Month of Issue: November 2001
Classification:
White
AUDIO TECHNICAL BULLETIN
Page 1 of 4
Sharp Electronics (UK) Limited
Reference AVW16112001-1
Revision 1
White – Carry out as required
Yellow – Carry out as required and whenever the unit comes in for service
Red – Carry out on all units
MODELS
CDBA1600H
CDBA1700H
CDBA2000H
CDBA2010H
REASON
When servicing the three-CD changer on any of the above models, please follow the
guidelines given on the following pages.
guidelines given on the following pages.
Removing Slide Holder from Chassis
1. Lift-up Lock Lever to unlock the Slide
holder.
holder.
2. At the same time, pull the Cam Gear
as shown while pushing forward the
slide holder.
as shown while pushing forward the
slide holder.
3. Remove the lock lever from the chassis.
4. Pull back the slide holder to the
previous position
previous position
5. Slowly lift-up the slide holder to
separate it from the chassis.
separate it from the chassis.
Reassemble Slide Holder to Chassis
1. Lift the stop lever to outside of slide
holder and hold to the position.
holder and hold to the position.
2. Slowly place the slide holder to the
chassis.
chassis.
3. Ensure that slide holder slots ( 4
positions) is aligned to the chassis
mounting.
positions) is aligned to the chassis
mounting.
4. Slowly push down the slide holder to
the chassis mountings.
the chassis mountings.
5. Firmly push the turn-table with two
finger while other hand pressing down
the slide holder.
finger while other hand pressing down
the slide holder.
6. Hold the cam gear as shown position
while push forward the slide holder.
while push forward the slide holder.
7. Push the slide holder forward until
lock lever assembly location expose.
lock lever assembly location expose.
8. Fixed back the lock lever with spring
and screw. Finally the 3 CD Changer is
ready to be fixed to the unit.
and screw. Finally the 3 CD Changer is
ready to be fixed to the unit.