Read Panasonic TY-ST42PT1E / TY-ST42PT1U / TY-ST42PW1E / TY-ST42PW1U / TY-ST42PF1E / TY-ST42PF1U / TY-WK42PV1E / TY-WK42PV1U / TY-WK42PR1E / TY-WK42PR1U Other Service Manuals online
2-
3
Instruction of the installation
Assembling the wall stand
1
Check the strength of the installation location.
The height measurements marked ** are particularly important. Do not
attempt to set up the pedestal in a location where these dimensions and a
clearance of at least 100 mm at the top of the display unit should be pro-
vided.
1) On the wall, measure and mark a height 650 mm above the floor;
2) Measure and mark the location 475 mm horizontally to the right of
the mark you made in 1). Measure and mark points 180 mm and 360
mm above each mark (for a total of six marked locations);
mm above each mark (for a total of six marked locations);
3) Drill a hole at each of the six marked locations on the wall.
Refer to the holding
bracket installation
measurements in the
drawing left.Ensure that
the wall is able to bear
the weight at each of the
4 upper and lower
installation locations.
Add reinforcement if any
of these locations are
not strong enough.
bracket installation
measurements in the
drawing left.Ensure that
the wall is able to bear
the weight at each of the
4 upper and lower
installation locations.
Add reinforcement if any
of these locations are
not strong enough.
Ensure an area of at least
650 mm by 1,230 mm in
length at the location
where you plan to install
the holding bracket.
650 mm by 1,230 mm in
length at the location
where you plan to install
the holding bracket.
The holding bracket has
6 slits through which the
bracket can be fixed to a
wall with screws.
6 slits through which the
bracket can be fixed to a
wall with screws.
If the wall material does
not allow sufficient
strength by using six
installation holes, use
some of the spare holes.
However, depending on
the construction material
used at the place of
installation, cracks may
develop if the screws are
inserted too close to
each other.
not allow sufficient
strength by using six
installation holes, use
some of the spare holes.
However, depending on
the construction material
used at the place of
installation, cracks may
develop if the screws are
inserted too close to
each other.
744
560
390
180
180
650
630
400
Units : mm
Wall installation holes
Spare wall installation holes (2 locations)
**
**
(4 locations)
floor surface
Click on the first or last page to see other TY-ST42PT1E / TY-ST42PT1U / TY-ST42PW1E / TY-ST42PW1U / TY-ST42PF1E / TY-ST42PF1U / TY-WK42PV1E / TY-WK42PV1U / TY-WK42PR1E / TY-WK42PR1U service manuals if exist.