Read Panasonic TX-28DK20D / TX-28DK20F (serv.man2) Service Manual online
HOW TO MOVE THE CHASSIS
INTO SERVICE POSITION
INTO SERVICE POSITION
1. Remove the bead clamper from the mains lead and
affix, using back cover screw, into top right-hand
cabinet rib (A), shown in Fig.4.
cabinet rib (A), shown in Fig.4.
2. Hold and lift the rear of the chassis and gently pull
the chassis toward you, as shown in Fig.4.
3. Release the respective wiring clips and rotate the
chassis vertically through 90
°
, anti-clockwise.
4. Locate the base of the chassis frame into location
(C), shown in Fig.5. / Fig.7.
5. Clip the chassis frame onto the bead clamper, shown
in Fig.5. / Fig.6.
6. After servicing replace the bead clamper and
speaker, and ensure all wiring is returned to its
original position before returning the receiver to the
customer.
original position before returning the receiver to the
customer.
SERVICEPOSITION FÜR DAS CHASSIS
1. Entfernen Sie den Kabelbinder von der Netzleitung und
befestigen Sie ihn mit einer Rückwandschraube am Gehäuse
an der Position (A). (Abb.4.)
an der Position (A). (Abb.4.)
2. Das Chassis am hinteren Ende anheben und vorsichtig
herausziehen (Abb.4.).
3. Die Kabelhalter werden gelöst und das Chassis gegen den
Uhrzeigersinn um 90º gedreht.
4. Das untere Ende des Chassis wird in die Halterung (C)
gesteckt (Abb.5. / Abb.7.).
5. Das obere Ende des Chassis wird in den Kabelbinder
eingehängt (Abb.5. / Abb.6.).
6. Nach der Reparatur wird der Lautsprecher wieder eingebaut,
der Kabelbinder entfernt und alle Kabelbäume auf die
Originalposition in die Halterungen eingesetzt.
Originalposition in die Halterungen eingesetzt.
5
Fig.5.
Abb.5.
(C)
Fig.4.
Abb.4.
(A)
Fig.6.
Abb.6.
Fig.7.
Abb.7.
Click on the first or last page to see other TX-28DK20D / TX-28DK20F (serv.man2) service manuals if exist.